Hey Paul, check this out, it's pretty cool.
Chris. Hoskins
https://youtu.be/VzCBQh8B_RY
I would say pretty hot ;-)
Paul Lamar
Oh VERY good ha ha ha
Chris Hoskins
It is a part of how Ford builds the new Aluminum F150 bodies.
Slightly different though in that the sheet metal is not perforated.
The process puts a dimple in the sheet and swelled on the back side
almost like a rivet but it is a sheet metal screw. With the metal not
perforated, water does not get there to start corrosion.
What
would a new Shelby GT350 be like with an all Aluminum body.
You could hydroform an Aluminum roll cage welded and bonded into the
structure as part of the safety systems and save 400 to
500 pounds off the car weight. It is already a potent track car that you
can drive to the movies on Friday night. Lighter by that much and it
would be like being fired out of a cannon
What if Ford built a larger rotary with 20mm eccentricity, 140mm radius
and 70mm rotor width you would have 2037cc displacement as Mazda
calculates it or 4.073L for racing or real. With Aluminum end housings
with detonation gun applied Cermet coating, TiAl or BeAl rotors and
power recovery you could take another 100 pounds off the front of the car.
You should be able to have a 12,000RPM red line and 580 to 650HP in
naturally aspirated form. Take that to LeMans and run against the
Camaro's and Ferrari's in the GT class.
Make the power recovery turbine housing out of TiAl or Inconel to save
weight.
Dale Davies
Forget about Le bloody Mans the bastards have outlawed it, they realised
that pistolas will never beat rotors. Just another example of
how the "real" world operates.
Chris Hoskins in NZ
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will remove you. ACRE
NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright 1998-2015 All world wide rights
reserved.