Subject: Engine RPM only 5900 2
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 11/9/2015, 2:23 PM
To: A10-me-earthlink



I would look at the mixture at 5,900 RPM with a EGT in each header and a heated oxygen sensor.
A heavy load at 5,900 RPM should be in the 12:1s..

The lack of  change past half throttle suggests intake disruption or blockage. and/or oversized throttle body.


The  stock 6 port intake although with short runners produced plenty of HP for the car. Another place to look is the accuracy of the TDC and timing marks on the pulley. You have to know for a fact what is the ignition timing. And the trailing never fires before the leading. Painting timing marks between the flywheel teeth is more accurate and easier to read.

A stalled propeller is easier to turn up than an unstalled propeller, so that should not be a factor.

Lynn E. Hanover

Lynn's got some good points as usual. Bob, do you have a manifold pressure gage?
If so what is it reading at 5900 RPM? Where is the manfold pressure tap mounted?

One bad one :) The stalled fix pitch  propeller. Every pilot knows that from a static run up.

Paul Lamar

Paul, Yes, I have a MP gauge, using Tracy's EM2.  MP tap is in the end of my intake air plenum, you can see it in the photo I sent earlier today (photo 036.jpg) opposite end from the throttle body. I had the MP ports originally located in the factory oil injection ports, however was not working properly.  Tracy told me to move it to the intake manifold plenum, made a big difference. At this time I'm hand mixing the oil and gas.  When I get this engine running properly (I hope!)I will no longer mix by hand.  I will be using the oil injection pump that I bought and installed and not mixing oil by hand with the fuel. I know you sell MP port fittings, however I do not wish to mix oil with the gas by hand as I did years ago in the old snowmobiles, pain the you know what.  MP @ 5900 RPM is 29.8

Thanks
Bob Forbes

That could be misleading the  computer.  There might be a strange dynamic pressure effect
with that huge ram pipe. The pressure is higher in the plenum than in the runners.
That would lead to a very rich mixture. Is there any black smoke coming out of the
exhaust? On the other hand the tapered plenum could have a strange effect with
the pressure tap on the small end.

What about Neal's question about the size of the injectors?

You could drill and tap all the runners for a 1/16th NPT to hose barb and Tee them all together.

A Maximite or a notebook computer and a USB data ack system would tell you for sure.
We learned tons when we did that on a p-port engine.

One of the problems with Tracy's system you have no way of knowing what it is
doing. The source code is secret and it keeps you in the dark. That problem would
be solved with a Maximite as you can display all parameters on a small VGA monitor
while it is going about it's biz of controlling the EFI.


Did you try the 2 blade at 68 inch diameter?

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.