This email is to address Scott Gettings wanting to know if anyone
else has a set-up like his Renesis 6 port. I have the same set-up
as Scott, and I'm using only the four yellow injectors and have the
two red ones blocked off, as per Tracy's direction.
However Scott, I cannot get over 5900 rpm. The engine rpm does not
increase after half throttle. I checked to make sure the throttle
body was opening all the way, and it is. I also removed my muffler
and replace it with a straight pipe thinking there might be an
restriction, not the case, made no difference in rpm. I chopped my
three blade 76" prop down to 68" and still no change in rpm. I'm
also using part of the original six port intake, with no runner
length. Now the only thing I can think of is the engine cannot get
enough air. Looks like I have no choice but to completely redo my
intake or try installing a super charger to force more air in. Not
sure if that will work or not. I'm using Tracy's EC3, EM2, & 2.87
PSRU.
Bob Forbes
The intake configuration and pipe length are critical for the HP.
The prop runs into a brick wall when the tips get close to Mach One.
What is your gear box ratio? Sounds like 2.2:1. A 3.12:1 would
work better with the rotary.
When the prop torque requirements meets the torque out of the gear
box the prop and engine of course will stop increasing in RPM.
You can move peak torque around with intake pipe length. You need
roughly 18 to 20 inches of intake pipe length. The longer the pipe
length the lower the torque peak RPM.
A p-port engine will increase the max torque at any pipe lenght.
So too will NOS :-) This is probably the cheapest and quickest.
Makes up for a lot of intake configuration errors :-)
A turbo charger is more economical than a super charger as it uses
the otherwise waste energy in the exhaust to super charge the
engine.
Paul Lamar
Bob please read this section of the web site.
http://www.rotaryeng.net/intake.html
Paul Lamar
Bob, Have watched this post with interest, but no answers. However
your post that the EGT is only 1400 degrees makes me ask if your
injectors are big enough. for I can get up to and over 1800 degrees.
Therefore it is possible that you are not getting enough fuel into
the engine??? My $0.10 worth.
Neil.
Good question.
The RX8 with side port exhaust ports is somewhat cooler on the exhaust.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.