Over the past 16 years we must have spent thousands of hours trying
to trouble shoot Tracy's EFI system with out adequate information.
On production cars this problem is solved with OBD II. OBD stands
for on board diagnostics and was mandated by the gov. OBD II sends
error codes to a connector under the dash board. This can be
connected to a PC with the proper cable. This is a very effective
system and can be diagnosed in seconds.
A maximite could do the same thing by displaying data from the
sensors and the pulse width of the injectors on a small VGA while it
was running the EFI.
My plate is full with the newsletter, my new ignition system, the
TTC project and up grading my NC mill. I have a small amount of time
to help if somebody would be kind enough take over this project. You
would be gaining a very valuable skill.
Paul Lamar
This sounds like a fascinating project. I've been looking for local
folks with racing/EFI/computer experience who might be willing to
assist. No luck so far, but I will keep looking. Might have
another good contact this weekend. It is clearly out of the scope
of my individual talents!
Scott Gettings
You under estimate your self. I know you better than that. It should
not take long.
Paul Lamar
I could do the code development but I have no way to test the results.
There's no way I can afford to buy the necessary hardware to develop or
test with.
Mark LaPierre
No problem Mark. I will supply the test hardware for you.
Do you have any hand tools and a place to do a little hardware
work.
In the mean time you can do this. When you get sufficient code written
I will send you stuff you can test it on.
The Maximite and DOS/QB hardware control development
systems are the only hardware control development systems where you do
not have
to build the actually target hardware to test them.
All output and control data, normally going to control hardware, is
merely
printed on the screen or saved in a text file along with the sensor
date that caused them to happen.
For an EFI system you can simulate the manifold pressure sensor with a
potentiometer.
The top of the pot is connected to 5 volts and the bottom is grounded.
The wiper is connected to an Analog to Digital pin on the Maximite.
You are now ready to start programming.
You can add a RPM input with a variable oscillator.
Or a variable speed drill motor revolving a short piece of steel and a
stock
crank angle sensor.
Here are some pictures.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.