I would say only several inches of additional temporary intake
manifold pressure. These 12 volt cooling fans are mass produced and
cheap.
BTW the motors are wired in parallel. Each stage has it's own
DC motor. Each stage runs at a different RPM and draws current
depending on aerodynamic load.
Paul Lamar
LOL...good idea
For fuel cell-vehicles a turbo blower is used to feed the stack and
linearise the output.
Our device had 80 kW blowers about the size of your PC-coolers.
Now the unit has a new duty in a airliner air conditioning system.
When used in an in line arrangement with an exhaust-turbine it is a nice
turbo-compound set up.
Also possible to get rid of the throttle body, the manifold pressure
will be controlled by the electronics.
Claude Jaeggi Germany
Oh how cute! Too bad it would only work at idle speeds. Maybe if you
started with a 10" diameter fan then slowly worked your way down to a 4"
diameter you could get both enough pressure and enough flow rate like
the jet engine developers do. ;-)
I enjoy your sense of humor my friend. Very funny.
On another note, I've done some design engineering on multistage
centrifugal blowers driven by an ICE feeding an afterburner sort of
arrangement for trust generation. The math was fun but I never built one.
P.S. I've tried the same trick with 120VAC fans extracted from old
industrial electroplating power supplies.
Mark LaPierre
More HP in the motors and your graduated diameters configuration
would certainly help a lot to make it truly functional.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.