How do I get up to speed on selecting and connecting
up a turbocharger for my airplane?
Gary Schwarz
The bible on this subject is Turbochargers by Hugh MacInnes.
See the attached files. There are a couple of others that
I listed that are not bad.
By far the best web site.
https://turbobygarrett.com/turbobygarrett/turbo_tech_basic
The stock Mazda Turbo II manifold cracks.
The second version is better than the first and
can be welded up and modified.
radius all sharp edges to at least 1/4 inch.
Mazda failed to do that.
Top of the line is an Inconel manifold.
If not that make it out of .125 thick 321 SS
tubing or plate.
Paul Lamar
Beautiful welding.
milo
A Maximite data acq system would be invaluable for a turbo installation.
The bottom line is how much boost do you get for x amount of exhaust
back pressure over a range of RPM's. That is related to fuel burn.
The Maximite will record at high speed up to ten parameters.
One book I was disappointed in was Turbocharging Performance Handbook
by Jeff Hartman. Mostly just pretty pictures.
Paul Lamar
Gary:
I am working on a turbocharged RX-8 also--mostly due to the complication
of TIG welding up 6 x 20" intake tubes draped over the top of the engine
(bellmouthed into a plenum) for the naturally aspirated intake-- and
also the noise factor which would require at least a 10 lb muffler.
It appears installing a turbo might be a wash in terms of labor to weld
intake and exhaust-and the overall weight (muffler possibly not required
for turbo version).
It appears an intercooler is a very good idea (if not required) as the
RX-8 has about a 10-1 compression ratio.
I am essentially looking to turbo normalize the RX-8 to get about
200-250 HP at any altitude < 18000' at 6000 rpm cruise and 7700 rpm
take-off (with Tracey's 2.85-1 reduction drive).
So far I have reduced the choices to:
T04E-50 trim, F1-62 turbine, A/R = 0.68 (possibly bigger). T4-4-bolt
flange, 3" dia. V-band outlet. 3" dia. compressor inlet & 2" dia.
outlet. External wastegate. See turbonetics catalog for details.
This is partly based on one flying in a Cozy IV with good results.
Let me know what you discover.
Regards,
Richard Craig
I don't recommend the six tubes over the top. It is much easier to take
the engine
apart and p-port it. Just spend some time to make a compartmented
container to
store all the seals so they go back in exactly where they came out of.
The engine is a lot easier to take apart and put back together than it
looks.
Don't be afraid of doing that. If you wish buy a old 12A or 13B and use it
for practice. Download shop manuals from here.
http://foxed.ca/index.php?page=rx7manual
Plan B is wait awhile until we get a handle on the Helmholtz resonator.
If that works you can just cut off a stock RX8 intake manifold and weld
on a rectangular tube.
A turbo is a good idea as it gives a lot of power and 10,000 feet
for high speed cruise. It also replaces the muffler.
http://www.turblown.net/store/index.php?categoryID=22
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.