Subject: Time to climb rotary coupling rubber bushings
From: paul lamar
Date: 11/20/2015, 11:05 PM
To: A10-Me-Earthlink







This was a steep learning curve for me. I built a female mould teflon
lined and tried to use hardware store clear silicon rubber. The
silicone took weeks to fully cure if ever.

I went on the web and found one or two solutions. One mixed dish
washing detergent in a bucket of water and you were supposed to put
the silicon in that and massage it until it starting getting hard.
That sort of worked but it was imprecise.

Another suggested pure glycerin as a catalyst.  As far as I can tell
that does not work at all.

Apparently there are two part silicone rubbers that do work but they
are really expensive. Apparently the colour is red.

I found red cured silicon rubber at McMaster one point five inches
thick relatively cheap at $60 for a six by six block 1.5 inches
thick.

It cut fine on my band saw.

So I made a pattern and printed it on label paper. The idea then is
to merely cut out the bumper rubber on the band saw.

Easier said then done. It toot several different  programs on two
different operating system to achieve those printed labels :-) Then
it was a pain getting the sticky label off the label backing paper.
The trick here is put a bit of masking tape on the label side and it
is much easier to peel it off the backing.

I then cut hard wood blocks to check the back lash.

I am now moving ahead much faster :-)

Paul Lamar



I have used this and others like it. Should work fine for this purpose. Yes
it's not cheap, but this product is capable of casting molten pewter. Heat
build up should not be an issue.

http://www.ebay.com/itm/AEROMARINE-PRODUCTS-HIGH-TEMP-RTV-SILICONE-MOLD-MAKING-RUBBER-2-QT-KIT-/301261649027?hash=item462497f483:g:LVEAAOSwQItT2AZ2

The RTVs are cheaper but not as heat tolerant. That being said, I have used
the RTV to cast plastic parts that are exothermic that hit 200 degrees
while curing with no problems at all.
Those are available for around $60 for half gallon.

Mix it up, pour it in and wait a bit.

Kevin Alderman


There is a difference. We are not making shell moulds but want to cast
thick rectangular  parts 1 by 1 by 1.5 inches in size. Will this
stuff cure in such mould that big? If you have a little left over
could you try it for me? Make me a solid rubber cylinder aprox. one inch
in diameter inch and a inch and a  half long. Use a one inch
diameter steel or aluminium tube as a female mold.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove  you.  ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.