This was a steep learning curve for me. I built a female mould teflon lined
and tried to use hardware store clear silicon rubber. The silicone took
weeks to fully cure if ever.
I went on the web and found one or two solutions.
One mixed dish washing detergent in a bucket of water and you were
supposed to put the silicon in that and massage it until it starting
getting hard. That sort of worked but it was imprecise.
Another suggested pure glycerin as a catalyst. As far as I can
tell that does not work at all.
Apparently there are two part silicone rubbers that do work but
they are really expensive. Apparently the colour is red.
I found red cured silicon rubber at McMaster one point five inches thick
relatively cheap at $60 for a six by six block 1.5 inches thick.
It cut fine on my band saw.
So I made a pattern and printed it on label paper. The idea then
is to merely cut out the bumper rubber on the band saw.
Easier said then done. It toot several different programs on two different
operating system to achieve those printed labels :-) Then it was a pain
getting the sticky label off the label backing paper. The trick here is
put a bit
of masking tape on the label side and it is much easier to peel
it off the backing.
I then cut hard wood blocks to check the back lash.
I am now moving ahead much faster :-)
Paul Lamar
Paul
Can I bring you a suggestion of pouring your silicone blocs
1st the upper part need 6 holes about .500"dia in line with the block
space room
2nd Prelubricate the upper part with a coat from a spray palm oil ca
to prevent silicone to stick on upper part surfaces .
3rd assemble both parts together.
4th pour true those .500"dia 6 holes
5th let it cure and disable
You will have a perfect adhered lower part block to the surface and no
backlash between lower and upper part.
Jean Prudhomme
Good Idea Jean. Back lash is a real issue.
I was going to inject a little un cured stuff into the assembly.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.