Subject: Time to climb rotary coupling rubber bushings 5
From: paul lamar
Date: 11/23/2015, 10:25 PM
To: A10-Me-Earthlink




This was a steep learning curve for me. I built a female mould
teflon lined and tried to use hardware store clear silicon rubber.
The silicone took weeks to fully cure if ever.

I went on the web and found one or two solutions. One mixed dish
washing detergent in a bucket of water and you were supposed to put
the silicon in that and massage it until it starting getting hard.
That sort of worked but it was imprecise.

Another suggested pure glycerin as a catalyst.  As far as I can
tell that does not work at all.

Apparently there are two part silicone rubbers that do work but
they are really expensive. Apparently the colour is red.

I found red cured silicon rubber at McMaster one point five inches
thick relatively cheap at $60 for a six by six block 1.5 inches
thick.

It cut fine on my band saw.

So I made a pattern and printed it on label paper. The idea then is
to merely cut out the bumper rubber on the band saw.

Easier said then done. It toot several different  programs on two
different operating system to achieve those printed labels :-) Then
it was a pain getting the sticky label off the label backing paper.
The trick here is put a bit of masking tape on the label side and
it is much easier to peel it off the backing.

I then cut hard wood blocks to check the back lash.

I am now moving ahead much faster :-)

Paul Lamar


Paul Can I bring you a suggestion of pouring your silicone blocs

1st the upper part need 6 holes about .500"dia in line with the
block space room

2nd  Prelubricate the upper part with a coat from a   spray palm
oil ca to prevent silicone to stick on upper part surfaces .

3rd assemble both parts together.

4th pour true those .500"dia 6 holes

5th let it cure and disable

You will have a perfect adhered lower part block to the surface and
no backlash between lower and upper part.

Jean Prudhomme

Good Idea Jean. Back lash is a real issue. I was going to inject a
little un cured stuff into the assembly.

Paul Lamar

Cutting it out of a solid block of red RTV was easy. Here is a
picture. I can squirt a bit of clear RTV from the hard ware store
upon final assembly. That will remove all back lash and it will
set up in 24 hours or less. With out doing that I estimate the back
lash at less than 5 degrees.

Paul Lamar

Here they are mounted to the male part of the coupling. It is easy
to glue them on with hardware store RTV.

I have not tried it yet but I am willing to bet this stuff can be
drilled as well. This may be necessary if the coupling proves to be
too stiff.

This stuff can be sanded on a belt sander as well.

Paul Lamar

Oversizing them [precompressing them] might decrease backlash even
further?

Gene Kahn

If they were over size assembly would be a real problem.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.