Subject: Turbo-side-Time to Climb 650 HP
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 2/11/2016, 11:41 AM
To: A10-me-earthlink


 Jim Mederer used a interesting technique to tune the turbo for
 aircraft use. Most turbos are designed for automotive use where
 fast spool up is necessary. The probelm with this is at high
 continuous aircraft power the turbine will over heat and or  over
 speed and fail.

 What Jim did was use a controlled leak in the exhaust manifold to
 get just enough boost.

 Works better than a waste gate with low A/R turbos.

 This has a side benefit of reducing the exhaust back pressure. Less
 back pressure more power.

 Paul Lamar

 Hi Paul. I don’t understand! I thought a waist gate was a controlled
 leak in the exhaust manifold.

 Steve Izett

Yes it is but it is a bit heavy and problematic.
This  is much simpler and and lighter weight.

The waste gate only measures the back pressure.
This device respons to the ratio of back pressure to atmosperica pressure.
I think it does a better job of keeping the HP matched to the altitude
change.

Of course the jury is still out until we fly it.


Paul Lamar


Paul,
What you should do is to use the largest turbine housing possible.
An AR of 1.44 would be about right.
Boost response for a car would be terrible but for an aircraft it would be perfect.
GM did this with the Corvair Turbo... no wastegate, just a large oversized turbine housing.
Barry Bordes


Sounds right to me. That is a large A over R.
Those are rare and expensive as far as I can tell.

Paul Lamar

 The Rotary Engine News Letter. Powered by Linux. If you want off
 the list PLEASE let me know and I will remove  you.  ACRE NL web
 site. http://www.rotaryeng.net/You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2016 All world wide rights reserved.