Subject: The amazing Time To Climb Mazda rotary engine.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 2/23/2016, 8:44 PM
To: A10-me-earthlink


The Formula One engine cost up to 100 million dollars and is  1.5
times the 200 pound weight of our TTC engine.

Paul Lamar

Hi Paul, do you have an article on the buildup of your 200 lb engine?
When I left the newsletter a few years back, Racing Beat were still
developing the aluminum engine plates, a check of their website still
does not list them. I would like to keep the weight down on the RX8
engine, where can I get al engine plates?

I use a Rotec TBI on the Funk with good results; and two 48mm TBIs on
the RX8 would be a good bet - slide throttles are part of the TBIs.

I really enjoyed working with Don D on the RX engines, especially the
coolant pump tests; I miss him still, and those pics brought back
good memories. Rs, Dave

I have this one but it does not talk much about the engine building
process. Basically the engine is stock with only minor mods here and
there. The oil pan is done away with and a scavenge pump is used
tocollect oil drain back from the rotors and main bearings.

I sprint car water pump is used instead of a Mazda water pump.

"This time Jim was able to extract 650 HP running on alcohol. Jim
also developed aluminium end housings that dropped the engine weight
from about 300 pounds to 200 pounds. The Mazda 13B block is a
sandwich of 5 castings. It is held to together with 17 long bolts.
The front, middle and rear are cast iron in the production engine.
Jim designed and had cast aluminium housing to replace the three
cast iron housings.

Lots of other engine changes were made. A dry sump oil system was
needed so the oil pan was done away with and replaced with AN
pluming that extracted oil directly from the center and front end
housings and send it to the oil cooler. A new larger capacity water
pump was needed. A p-ported was chosen in instead of the stock side
ports.

A Motec after market EFI system was chosen to supply fuel to the
engine. That came with an EFIS. The rotors are modified stock rotors
as is the eccentric shaft."

Here are some more pictures of the engine.

Paul Lamar

Hi Paul, I was looking at the engine and I noticed that it has got
side as well as peripheral ports, why is this ? Chris.


The side ports are blocked off. Those end housings where designed
years ago when people thought low RPM torque was necessary.  They
were wrong :-)

HP is king. You can get all the low RPM torque you need with gears.

Paul Lamar


You need to check the RB website. Those aluminum side housings
can be ordered with side ports or left plugged for use with p-ports.
The manifold end just needs plates or thin epoxy film over tin foil.

Dale Davies



The Rotary Engine News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove  you. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.