Subject: Why the Wankel works so well in Light aircraft.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 3/6/2016, 7:56 AM
To: A10-me-earthlink

This is an excerpt from a book by Herschel Smith called "A History of
Aircraft Piston Engines" published by Sunflower University Press Inc. 1531
Yuma, Manhattan, Kansas 66502-4228. ISBN 0-07-058472-9. There are
250, 8.5 by 11 pages. It chronicles the evolution of the [light] aircraft engine from
early days to the present. There are many tables listing every engine
ever put in an airplane with all important specifications including weight,
horsepower, RPM, configuration and in some cases BSFC. There are many
photos and drawings of all types of intermittent combustion aircraft engines.
This is as close to a bible of intermittent combustion aircraft engine history
that I have found so far. No jets or turbo props.

The conclusion is a major reason on why the Wankel makes such a good
light aircraft engine.

"Chapter TEN  The opposed engine.

The Rationale of the Opposed Engine

Every piston engine in production today, outside of the Soviet bloc, is of the opposed type. It has displaced all others wherever buyers. and designers are free to choose.
Its merits lie not in any single area of outstanding superiority but in having an optimum combination of qualities for today's conditions and airframe designs.

The replacement of a radial by a flat engine in the Bellanca demonstrates this combination. In its pre-war incarnation as the model 14, the Cruisair was a two- to three-place airplane powered by a 95-hp Ken-Royce radial. By 1948 it had become a four-placer with a 150-hp Franklin opposed six up front. Eventually it went over 200 hp with a flat engine and acquired a tricycle gear. Visibility over the nose of the original model was barely acceptable; with a 150-hp radial it would have been impossible. A 150-hp radial would have had a diameter over the cowling of about 44 in. (1120 mm), more than the fuselage width and high enough to demand extra fuselage depth in order to let the pilot see past the engine. To begin with, then, both visibility and streamlinIng are better on small planes when opposed engines are used.

In addition, there is usually no weight penalty involved in the use of an opposed engine instead of a radial. A radial would be lighter for the same power if it had the same number of cylinders, but it doesn't; in the interest of smoothness, it needs more. A major source of vibration that plagues other types of engines is largely eliminated on opposed engines because their pistons come together and move apart in pairs, and this makes it practical to use fewer but larger cylinders. This, as we have noted earlier, makes for a lighter engine and allows the flat engine to be at least competitive with the small radial with regard to weight. Modem vibration-absorbing mounts help, of course. Because of both of these factors, we can now make flat fours in sizes that would have called for 7 cylinders in a radial.

The rpm of opposed engines tend to be higher than those of radials. This is a disadvantage from the standpoint of propulsive efficiency, but this is minimized by the availability of constant-speed propellers in the lower power ranges. In addition, the higher revs call for smaller propeller diameters, which go well with tricycle gear."

The distance from the eccentric shaft to the top of the Wankel is no larger than most horizontal
opposed aircraft engines and mounting the turbo charger on one side and the cooling system
on the other fits most  side by side aircraft perfectly.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.