Subject: My new mini motor home to go to airshows
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 3/25/2016, 9:39 PM
To: A10-me-earthlink


I can take rotary engine parts with me which is not practical if I
fly. Not to mention the savings in hotel rooms and rental cars. I can
also take a nap in the after noon :-)

I bought a Dodge Ram Promaster 110 inch wheel base version. As far as
I can tell it is the only monocoque (unit body) front drive van with
62 inches of head room on the market. The floor is only 21 inches
from the ground. Standard roof. It is 1000 pounds lighter than your
typical rear drive channel steel frame sport ute, pick up truck or
van chassis. That means it gets much better gas mileage. At 50 MPH
rolling drag is half the the total drag so weight has a large affect
on low speed MPG. Payload is about 4000 pounds. It will tow 5000
pounds.

The turning circle is 36 feet which makes it easy to manoeuvre in
tight places and to parallel park. One can park it anywhere. Even in
residential areas. Not true for most motor homes.

It gets about 20 MPG at a steady 65 MPH. The side view mirrors
electrical retract and that adds 2 to 3 MPG more on the flat at 65
MPH. There is an instant MPG read out on the instrumental panel
display.

The engines is a Mercedes design 3.6 L V6 with six speed auto
transmission. 24 gallon fuel tank with over 500 mile range. The
intake manifold maintains peak torque from 1600 to 6400 RPM. 280 HP
and 260 ft pounds of torque.

That is almost as good as the RX8 intake manifold however not as much
torque. The RX8 is only 2.6 L and not 3.6 L.  If we ever get a 16B
that would be 3.2 L. A 3 rotor is 3.9 L. Torque deficiencies can be
made up with a good multi speed auto transmission if you have the HP
of course.

Paul Lamar

Paul, I would be very interested in your report on the Promaster when
you have dug into it a bit. It is a Fiat Ducato and my friends in Europe
who have them like them a lot (although they typically have much smaller
and diesel engines.) There has been a lot of Detroit engineering since
they got some ideas from Mercedes on that engine. A lot depends on how
well the Dodge dealers are equipped to handle it, but since that engine
is used in a lot of Chrysler products it should be fine.

David Josephson

Yes I knew about the Fiat history. Pickup trucks are outlawed
in Europe because it is too easy for debris to be blown out of
the bed, Arguably  automotive  chassis design is more advanced
in Europe. I have about 2000 miles on it so far. One trip to northern
California and back. The ride is great for a truck.

I am amazed about the number of sport utes out there still
using the archaic dual channel steel frame. Most vans
with this kind of frame or rear drive vans have two steps up
while this one has one.

The rear drive  Mercedes Sprinter is too narrow
and too high IMHO. It probably gets blown around  real bad when
be passed by a tractor trailer.


The US PO is in the market for new vans
with standing head room. They would do well choosing this one.
What is under the floor is all important.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.