I can take rotary engine parts with me which is not practical if I
fly. Not to mention the savings in hotel rooms and rental cars. I
can also take a nap in the after noon :-)
I bought a Dodge Ram Promaster 110 inch wheel base version. As far
as I can tell it is the only monocoque (unit body) front drive van
with 62 inches of head room on the market. The floor is only 21
inches from the ground. Standard roof. It is 1000 pounds lighter than
your typical rear drive channel steel frame sport ute, pick up truck
or van chassis. That means it gets much better gas mileage. At 50
MPH rolling drag is half the the total drag so weight has a large
affect on low speed MPG. Payload is about 4000 pounds. It will tow
5000 pounds.
The turning circle is 36 feet which makes it easy to manoeuvre in
tight places and to parallel park. One can park it anywhere. Even in
residential areas. Not true for most motor homes.
It gets about 20 MPG at a steady 65 MPH. The side view mirrors
electrical retract and that adds 2 to 3 MPG more on the flat at 65
MPH. There is an instant MPG read out on the instrumental panel
display.
The engines is a Mercedes design 3.6 L V6 with six speed auto
transmission. 24 gallon fuel tank with over 500 mile range. The
intake manifold maintains peak torque from 1600 to 6400 RPM. 280 HP
and 260 ft pounds of torque.
That is almost as good as the RX8 intake manifold however not as
much torque. The RX8 is only 2.6 L and not 3.6 L. If we ever get a
16B that would be 3.2 L. A 3 rotor is 3.9 L. Torque deficiencies can
be made up with a good multi speed auto transmission if you have the
HP of course.
Paul Lamar
if you bought it new, I assume it’s the 118” wheelbase model?
Are you going to turn it into a Class-B RV?
Do the wall ribs lend themselves to attaching hanging cabinets, fold
down beds, plumbing and other creature comforts?
Will you install at least a portipotti, deep cycle batteries & a generator?
Barry Gloger
Yes your right 118 inch WB.
No windows so it will look like a Cargo Van.
Yes on the ribs.
Yes on the porta pottie. WalMart has a good one for about $60.
No deep cycle batteries yet. Funny you should mention a generator.
I am building a 12V one as we speak. Kaboto permanent magnet field
I had laying around. Very simple wiring and no field so it will
put out 12 Volts with no battery connected.
It has an electric start. All you need is a half inch battery
drill motor. The device you see is a socket and one way shaft
clutch. The socket fits the nut on the crank shaft. Works
great.
The Kaboto is geared up to run about 3 times the RPM of the
engine so it will charge a 12 V battery in a few minutes of running.
Sufficient to get the van engine running.
An electric blanket will keep me warm with a max of 10 amps
out of the battery. I have a 1600 Watt inverter for 110V AC.
Inverters are getting cheaper and more powerful taking
advantage of recent improvements in solid state switches.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.