Subject: Power = take off ?
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 3/30/2016, 9:26 AM
To: A10-me-earthlink


 Hi ,

 I am planning on building a canard either the VARIEZE or LONG-EZ
 because I would like to build an aircraft to travel long distances.

 One of the drawbacks of a canard is that it requires a long runway
 for take off.

 There is a canard called the IBIS Canard a wooden structure using a
 direct drive air cooled VW 65 HP. His thinking behind it is that the
 maximum rpm for propeller is 2700 so as the engine idles @ 1000 rpm
 he reached Max propeller rpm @ 3700. He even says 85 HP would cause
 extra fuel consumption.

 https://www.junqua-aircraft.com/html/framegene.htm

 I was wondering by having an increased HP with reduction drive and
 relevant propeller, Can one dramatically shorten the take off
 distance of a CANARD like the VARIEZE or LONG-EZ ?

 Zahid Rahman

 Sure! all it takes in HP. Go see Emon Hurley at Hurley Engineering in
 Coventry and get him to build a P-port two rotor with 250 HP and
 install it in a Long EZ.

 If the prop is 50% efficent at 50 feet per second forward speed you
 will have  HP = 125 = 68750  pound feet per second.

 So at 50 feet per second you have  1,375 pounds of thrust. That is
 just about what a Long EZ weighs so basically the airplane will
 accelerate initially at well over  one G. One G is 32 feet per second
 per second.

 You will be doing about 80 MPH in about 3 seconds. and a couple of
 hundred feet down the runway.

 65 HP would barely make it fly.

 With a p-port rotary it would do well over 200 MPH.

 Paul Lamar

Hey Zahid,

  I too am building a long EZ, actually I have two, and I bought a rebuilt 13B out of a mazda to use. I am convinced Paul is right. Much more HP and a smaller package. Keep us posted on your progress. This is all new territory for me so I can use all the help I can find. A friend has a bush plane that is fun to fly but you can’t get any where with it as it is too slow. My wife and I love to frequent the Moab Utah area… 1000 miles away, 2 days drive, but with a near 200 mph plane its only 5+ hours. I think I live on the edge of the planet, I don’t know of anybody out here that has experience with converting a rotary to aircraft use. I’m wondering… where is Coventry? I bet its on the east coast. Is there anybody out here in the Pacific northwest that knows their stuff? Specifically the Oregon coast?

         Regards Jess Choat.

This one has been flying for over 600 hours. Owned and built by Perry Mick.
The engine is solidly bolted into the air frame. It also has a stock RX7
instrument panel. I uses a stock RX7 ECU.

Paul Lamar



 The Rotary Engine free News Letter. Powered by Linux. If you want off
 the list PLEASE let me know and I will remove  you.  ACRE NL web
 site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2016 All world wide rights reserved.