Subject: If we do our own billet end housings
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 4/1/2016, 7:14 PM
To: A10-me-earthlink


 New structure for the rotary' We might as well fix the 3 rotor and 4
 rotor e-shaft cost problem and make the block like an Offenhauser.
 One of the strongest engines ever made. It still holds the record for
 HP per cubic inch.

 Basically a main bearing clamp is inserted into the centre housings
 and the e-shaft is one piece.

 This puts a centre main into a two rotor as well.

 Paul Lamar

Paul,
The Offy was truly amazing in the amount of boost it would tolerate.
Returning to the rotary, the Curtis-Wright venture into the rotary did
occasion this patent. Likely not to have been maintained, which would make
it public domain now.


The other big advantage the 1 piece e-shaft allows is
not needing the wide intermediate housing of the 3 rotor, or even the wide
center housing of the 2 rotor. Using the 1 piece e-shaft and multiple main
bearings you should be able to make a 4 rotor the same length as the Mazda
3 rotor, or at least very close to it. It would need to be dry sump of
course, but many of us planned that from the start.

 If I had the money and
time that's the way I'd do it! The attached files are a photo of the early
version of the patent and the actual patent drawing. You may have had the
photo on the newsletter at one time. I remember seeing it shortly after I

Bill Jepson

Good job Bill !! You are saving all my pictures I up loaded :-)
That pic of the trick center main I took at Hayes Rotary Engineering
when they were asked to over haul one.

Here are some more from CW.

Paul Lamar

 The Rotary Engine free News Letter. Powered by Linux. If you want
 off the list PLEASE let me know and I will remove  you.  ACRE NL web
 site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2016 All world wide rights reserved.