New structure for the rotary' We might as fix the 3 rotor and 4 rotor
e-shaft cost problem and make the block like an Offenhauser. One of
the strongest engines ever made. It still holds the record for HP per
cubic inch.
Basically a main bearing clamp is inserted into the centre housings
and the e-shaft is one piece.
This puts a centre main into a two rotor as well.
Paul Lamar
Very similar to a VM Motori Tunnel Bore six !
"Two further important characteristics of the HR engine are the tunnel
shaped block and the separated cylinder heads. The block is built
entirely from cast iron, in which a tunnel for the crankshaft is left
open. The usual main bearing caps that support the crankshaft are
integrated in the engine block. In the direction of the sump the engine
has five barriers in between each cylinder. Through these barriers runs
one single tunnel in which the crankshaft is built in. The crankshaft in
its turn is supported by five strong aluminium main bearings. These
bearings are not connected to the tunnel. With the engine running, the
expansion of the aluminium being three times greater than that of steel
presses the bearing tightly to the block. The thick layer of aluminium
between the crankshaft and the iron block is a perfect 'sandwich panel'
to reduce engine vibrations and noise."
Steve Carlisle
I think Offenhauser thought of it first back in the 1930's.
https://en.wikipedia.org/wiki/Offenhauser
The most they got was about 3 HP per cubic inch.
Mazda 13B is 2.6L = 159 cubic inch.
Our 13B time to climb engine is 650 HP divided by 159 cubic inches or 4HP
per cubic inch.
So our time to climb engine beats the offy by having 4 HP per cubic inch.
An amazing result for such a cheap engine.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.