Subject: Trip to Sun n Fun from California
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 4/13/2016, 10:44 AM
To: A10-me-earthlink


Hey Paul,

Welcome back from Sun-N-Fun.  I hope you had a good time.

Mark LaPierre

Thanks Mark. I drove my Dodge mini motor home. BTW Loves truck stop
rents one a spotlessly clean bath room with three fresh large towels
for $11 so one can take a shower.

I installed an inverter so I could use a small room heater to heat
the van while I was sleeping. The low setting was 900 watts. One has
to be careful to not run down the battery so far it will not start
the engine.  A electric blanker is a better solution as they are
only 130 watts. I need a voltage alarm that wakes me up when the
battery gets down to 10 volts or so.

Here is a connector I found at Home Depot. The 1600 watt 110 Volt AC
inverter takes a lot of current out of the battery.  Up to 130 Amps
so you need big wire and a big battery. So I bought a second 12 volt
battery at Walmart for $50 and wired it in parallel with the stock
battery under the driver's floor. Double current.  The 2nd battery
is located behind the driver seat to keep the wires short. The red
and black wires go to the inverter in this picture. The engine
alternator charges both batteries no problem.

Finding large enough wire to carry the current was tricky. Home Depot
to the rescue again. They sell #2 wire .25" in diameter stranded
copper. Max amps 181. .156 ohms per thousand feet.

Paul Lamar


You need a battery isolator.... Leaves the starter battery out of the
invertor setup.

Darren Dueck

I considered it but that would reduce the available current with only
one additional cheap 12 volt battery. The deep cycle batteries are
expensive at over $100.

I decided to not use deep cycle and limit the use to 10 Volts for
both. The van engine will still start on 10 volts.

Walmart is everywhere and the price is half what a deep cycle will
cost. I will see how it goes.

I also considered a switch to disconnect the van battery but could
not find one with the required current capability.

If any one knows of one capable of 200 amps please let me know.

Paul Lamar


Paul,

Jegs has an assortment of switches at:

http://www.jegs.com/i/Moroso/710/74102/10002/-1

And if you convert your cables to ring style ends you can connect to marine type battery connections:

http://www.jegs.com/i/JEGS+Performance+Products/555/10328/10002/-1

Makes battery removal and connections as easy as side post battery connections


ray hellstrom

Expensive but exactly what I was looking for.

Thanks Ray.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.