Subject: Trip to Sun n Fun from California
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 4/13/2016, 12:01 PM
To: A10-me-earthlink



 Hey Paul,

 Welcome back from Sun-N-Fun.  I hope you had a good time.

 Mark LaPierre

 Thanks Mark. I drove my Dodge mini motor home. BTW Loves truck stop
 rents one a spotlessly clean bath room with three fresh large towels
  for $11 so one can take a shower.

 I installed an inverter so I could use a small room heater to heat
 the van while I was sleeping. The low setting was 900 watts. One has
  to be careful to not run down the battery so far it will not start
 the engine.  A electric blanker is a better solution as they are only
 130 watts. I need a voltage alarm that wakes me up when the battery
 gets down to 10 volts or so.

 Here is a connector I found at Home Depot. The 1600 watt 110 Volt AC
  inverter takes a lot of current out of the battery.  Up to 130 Amps
  so you need big wire and a big battery. So I bought a second 12 volt
  battery at Walmart for $50 and wired it in parallel with the stock
 battery under the driver's floor. Double current.  The 2nd battery is
 located behind the driver seat to keep the wires short. The red and
 black wires go to the inverter in this picture. The engine alternator
 charges both batteries no problem.

 Finding large enough wire to carry the current was tricky. Home
 Depot to the rescue again. They sell #2 wire .25" in diameter
 stranded copper. Max amps 181. .156 ohms per thousand feet.

 Paul Lamar


 You need a battery isolator.... Leaves the starter battery out of the
 invertor setup.

 Darren Dueck

 I considered it but that would reduce the available current with
 only one additional cheap 12 volt battery. The deep cycle batteries
 are expensive at over $100.

 I decided to not use deep cycle and limit the use to 10 Volts for
 both. The van engine will still start on 10 volts.

 Walmart is everywhere and the price is half what a deep cycle will
 cost. I will see how it goes.

 I also considered a switch to disconnect the van battery but could
 not find one with the required current capability.

 If any one knows of one capable of 200 amps please let me know.


 Paul Lamar

Paul,
With your racing background I'm surprised you didn't think of the main
battery disconnect switch required by many racing organizations. Summit has
a bunch of them. they start at 100 amps and I saw one rated at over 300
amps continuous. Summit Racing web site.
Bill Jepson

Last time I wired a race car was in 1965.
Us engineers leave that to the mechanics :-)
When you get my age the first thing to go is your memory :-)

 BTW I stopped in Bristol Tennessee to see my old friend Herb Adams.
Herb is the father of the Transam Firebird while at GM and has raced in all
most all classes. He is building a completed kit car called the Princess.
Ready to go..... you just have to drop in an engine of your choice.
Great for a 3 or 4 rotor.  Roll up windows and door crash beams.

It has a massive cast aluminium front and rear clips with an aluminium
back bone frame for high torsional stiffness. Beats Cobra's in  road racing
consistently.

He might be on HP for an Hour soon.


Paul Lamar


 The Rotary Engine free News Letter. Powered by Linux. If you want off
 the list PLEASE let me know and I will remove  you.  ACRE NL web
 site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2016 All world wide rights reserved.