Subject: Trip to Sun n Fun from California
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 4/13/2016, 7:32 PM
To: A10-me-earthlink




  Hey Paul,

  Welcome back from Sun-N-Fun.  I hope you had a good time.

  Mark LaPierre

  Thanks Mark. I drove my Dodge mini motor home. BTW Loves truck stop
  rents one a spotlessly clean bath room with three fresh large towels
  for $11 so one can take a shower.

  I installed an inverter so I could use a small room heater to heat
  the van while I was sleeping. The low setting was 900 watts. One has
  to be careful to not run down the battery so far it will not start
  the engine.  A electric blanker is a better solution as they are
  only 130 watts. I need a voltage alarm that wakes me up when the
  battery gets down to 10 volts or so.

  Here is a connector I found at Home Depot. The 1600 watt 110 Volt AC
  inverter takes a lot of current out of the battery.  Up to 130 Amps
  so you need big wire and a big battery. So I bought a second 12 volt
  battery at Walmart for $50 and wired it in parallel with the stock
  battery under the driver's floor. Double current.  The 2nd battery
  is located behind the driver seat to keep the wires short. The red
  and black wires go to the inverter in this picture. The engine
  alternator charges both batteries no problem.

  Finding large enough wire to carry the current was tricky. Home Depot
  to the rescue again. They sell #2 wire .25" in diameter stranded
  copper. Max amps 181. .156 ohms per thousand feet.

  Paul Lamar


  You need a battery isolator.... Leaves the starter battery out of the
  invertor setup.

  Darren Dueck

  I considered it but that would reduce the available current with only
  one additional cheap 12 volt battery. The deep cycle batteries are
  expensive at over $100.

  I decided to not use deep cycle and limit the use to 10 Volts for
  both. The van engine will still start on 10 volts.

  Walmart is everywhere and the price is half what a deep cycle will
  cost. I will see how it goes.

  I also considered a switch to disconnect the van battery but could
  not find one with the required current capability.

  If any one knows of one capable of 200 amps please let me know.

  Paul Lamar


Paul,

Jegs has an assortment of switches at:

http://www.jegs.com/i/Moroso/710/74102/10002/-1

And if you convert your cables to ring style ends you can connect to marine type battery connections:

http://www.jegs.com/i/JEGS+Performance+Products/555/10328/10002/-1

Makes battery removal and connections as easy as side post battery connections


ray hellstrom

Expensive but exactly what I was looking for.

Thanks Ray.

Paul Lamar

Good OK go for it!

Milo Burrows

I found a cheaper version at West Marine of all places.
It was half the cost ($31) with higher ratings.
300 amp continuous.

It was made in the states by Blue Sea Systems.

Paul Lamar


 The Rotary Engine free News Letter. Powered by Linux. If you want
  off the list PLEASE let me know and I will remove  you.  ACRE NL web
  site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
  Copyright 1998-2016 All world wide rights reserved.