Hey Paul,
Welcome back from
Sun-N-Fun. I hope you had a good time.
Mark LaPierre
Thanks Mark. I drove my Dodge mini motor
home. BTW Loves truck stop
rents one a
spotlessly clean bath room with three fresh large towels
for $11 so one can take a shower.
I installed an inverter
so I could use a small room heater to heat
the van while I was sleeping. The low
setting was 900 watts. One has
to be
careful to not run down the battery so far it will not
start
the engine. A electric blanker
is a better solution as they are
only
130 watts. I need a voltage alarm that wakes me up when
the
battery gets down to 10 volts or
so.
Here is a
connector I found at Home Depot. The 1600 watt 110 Volt
AC
inverter takes a lot of current out
of the battery. Up to 130 Amps
so
you need big wire and a big battery. So I bought a second 12
volt
battery at Walmart for $50 and
wired it in parallel with the stock
battery under the driver's floor. Double current. The
2nd battery
is located behind the
driver seat to keep the wires short. The red
and black wires go to the inverter in
this picture. The engine
alternator
charges both batteries no problem.
Finding large enough wire to carry the
current was tricky. Home Depot
to the
rescue again. They sell #2 wire .25" in diameter
stranded
copper. Max amps 181. .156
ohms per thousand feet.
Paul Lamar
You need a battery isolator.... Leaves
the starter battery out of the
invertor setup.
Darren Dueck
I
considered it but that would reduce the available current
with only
one additional cheap 12 volt
battery. The deep cycle batteries are
expensive at over $100.
I decided to not use deep cycle and limit the use to 10
Volts for
both. The van engine will
still start on 10 volts.
Walmart is everywhere and the price is half what a deep
cycle will
cost. I will see how it
goes.
I also
considered a switch to disconnect the van battery but
could
not find one with the required
current capability.
If any one knows of one capable of 200 amps please let me
know.
Paul Lamar
Paul,
Jegs has an assortment of
switches at:
http://www.jegs.com/i/Moroso/710/74102/10002/-1
And if you convert your cables
to ring style ends you can connect to
marine
type battery connections:
http://www.jegs.com/i/JEGS+Performance+Products/555/10328/10002/-1
Makes battery removal and
connections as easy as side post battery
connections
ray hellstrom
Expensive but exactly what I
was looking for.
Thanks
Ray.
Paul Lamar
Good OK go for it!
Milo Burrows
I found a cheaper version at
West Marine of all places.
It was half the
cost ($31) with higher ratings.
300 amp
continuous.
It was made in
the states by Blue Sea Systems.
Paul Lamar
The
only problem I had with the Blue Sea was the size of the
terminal bolts.
3/8th instead of 5/16th. The
home depot connector is only good to 5/16th
so I made my own out of brass to handle the #2
wire size.
Paul Lamar
Use a battery isolator and add another battery for your heater. Never
lose power off your auto battery.
Angel Lopez
Do you drag race rotaries Angel?
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.