Sent from my Bell Samsung device over Canada's largest network.--------
Original message --------From:
rotaryeng@earthlink.net Date: 04-25-2016
5:53 AM (GMT-07:00) To: A10-me-earthlink
<rotaryeng@earthlink.net>
Subject: More power for the road racers.
The current intake manifold the road racers is not
tuned. The rotary demands a tuned manifold.
That is why Mazda spent so much time and money
designing a very complicated tuned manifold for the RX8.
They succeeded wonderfully with almost a flat torque
curve from 3000 RPM to 9000 RPM. This is also extremely
important for low BSFC throughout that RPM range.
Keep it in sixth gear around town and you will
get over 20 MPG. 25 MPG on the highway.
The SCCA road racers on the other hand just need a lot
of HP in the 8000 to 11,000 RPM range.
Peak HP at 8000 RPM requires a tuned length of 10 inches.
The manifold most use now is not tuned. Here is a picture
of that manifold.
Side ports are required in most of the SCCA classes.
P-ports are not allowed. P-ports and reasonable
car weight with out ballast would put any rotary
powered car at the top of all the classes in terms of
low lap times. It would then be pointless to race
most of the other old piston powered cars most people race.
The RX8 with 200 pounds of ballast dominates stock
classes on the west cost.
So one will need 4 side port runners 10 inches long.
The way to do that is use two 40 MM weber copy
carbs. Each carb has two throats. Mazdatrix sells them.
Total length from port to the top of the bell mouth.
For best results keep the bell mouth as short
as possible. You will also need a cold air box on
top of both carb as there is a lot of fuel mist
that hovers above the tuned intake carbs. You can see that in
this you tube video.
https://www.youtube.com/watch?v=NKJ00JsnS8A
This has been done on high power VW's and Porsches for years.
Here are some 3D's and photo's on the subject.
Paul Lamar
Paul, in 1973 the port timing and carb manifold gave a flat torque curve
once 3500 RIM was reached. The torque climbed from idle quickly. A VW
Beetle could out accelerate you if you just engaged the clutch at idle
and then punched it. Then at 3500 RPM it was like a V8 kicked in. When
the RX7 was introduced the timing had been revised and the engines did
not have the kick at 3500 like a two stroke coming on the ports.
Dale Davies
The Rotary Engine free News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.