Subject: More power for the road racers.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 4/25/2016, 8:41 AM
To: A10-me-earthlink



 The current intake manifold the road racers is not tuned. The rotary
 demands a tuned manifold.

 That is why Mazda spent so much time and money designing a very
 complicated tuned  manifold for the RX8. They succeeded wonderfully
 with almost a flat torque curve from 3000 RPM to 9000 RPM. This is
 also extremely important for low BSFC throughout that RPM range.

 Keep it in sixth gear around town and you will get over 20 MPG. 25
 MPG on the highway.

 The SCCA road racers on the other hand just need a lot of HP in the
 8000 to 11,000 RPM range.

 Peak HP at 8000 RPM requires a tuned length of 10 inches. The
 manifold most use now is not tuned. Here is a picture of that
 manifold.

 Side ports are required in most of the SCCA classes. P-ports are not


The current intake manifold the road racers is not tuned. The rotary demands a tuned manifold. That is why Mazda spent so much time and money designing a very complicated tuned  manifold for the RX8. They succeeded wonderfully with almost a flat torque curve from 3000 RPM to 9000 RPM. This is also extremely important for low BSFC throughout that RPM range. Keep it in sixth gear around town and you will get over 20 MPG. 25 MPG on the highway. The SCCA road racers on the other hand just need a lot of HP in the 8000 to 11,000 RPM range. Peak HP at 8000 RPM requires a tuned length of 10 inches. The manifold most use now is not tuned. Here is a picture of that manifold. Side ports are required in most of the SCCA classes. P-ports are not allowed.  P-ports and reasonable car weight with out ballast would put any rotary powered car at the top of all the classes in terms of   low lap times. It would then be pointless to race most of the other old piston powered cars most people race. The RX8 with 200 pounds of ballast dominates stock classes on the west cost. So one will need 4 side port runners 10 inches long. The way to do that is use two 40 MM weber copy carbs. Each carb has two throats. Mazdatrix sells them. Total length from port to the top of the bell mouth. For best results keep the bell mouth as short as possible. You will also need a cold air box on top of both carb as there is a lot of fuel mist that hovers above the tuned intake carbs. You can see that in this you tube video. https://www.youtube.com/watch?v=NKJ00JsnS8A This has been done on high power VW's and Porsches for years.
Here are some 3D's and photo's on the subject.


Paul Lamar


Paul - most classes are limited to ONE 2-barrel carb AND a "DUAL "Y""
manifold. Meaning EACH runner feeds ONE rotor.

Dave Lemon

Yes I just found that out from my SCCA racer friend.

I have another idea using a Helmholtz resonator.

I will be working on some new dwgs.

It will take some electronic trickery to tune it.
Here are the Helmholtz resonators on my Honda
Odyssey

Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off the list PLEASE let me know and I will remove  you.  ACRE NL web site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas Copyright 1998-2016 All world wide rights reserved.