Kevin Richey actually has 40 of these engines.
In theory it is possible to convert them from charge cooled
to oil cooled. I can show you how.
Kevin is interested in selling a few. Kevin is in the Portland area.
Paul Lamar
I am definitely interested in buying a few more and I would like to
change my mine from charge cooled to oil cooled so please show us how
David Mikesell
The hardest part is adding an oil seal to the rotor to keep
oil smoking down. It can be a spring loaded short steel thin cylinder.
Similar to a Mazda rotor oil seal.
All roller bearings are replaced by oil fed plain beatings.
The oil seal goes about where the red line is on this picture of the
rotor on both sides. An oil squirter is added to the e-shaft and holes
drilled to supply oil to the plain main and rotor bearings. A bushing is
added to the rotor to accommodate a plain rotor bearing.
Kevin email address is:
Kevin Richey
<gyroKevin@gmail.com>
Paul Lamar
Once converted, what would the HP/Torque/RPM values be like?
Bradly Windsor
Surprisingly the displacement is almost as large as a single rotor
Mazda 12A.
It is therefore likely to be similar.
The compression ratio is rather low at 8.5 to one so screwing inserts
into the bath tub depression in the face of the rotor to up
the compression ratio would work.
Here are the basic specs.
BTW Back in WW II CW improved the cooling on the air cooled R3350 by
pressing additional sheet metal finning between the cast cooling fins on
the cylinder
heads. It sounds likely the same trick will work on this engine to improve
the continuous HP rating.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.