Subject: Visit with the OMC snowmobile rotary engine King.
From: paul lamar
Date: 5/26/2016, 9:24 AM
To: A10-Me-Earthlink



Kevin Richey actually has 40 of these engines.


In theory it is possible to convert them from charge cooled
to oil cooled. I can show you how.

Kevin is interested in selling a few. Kevin is in the Portland area.

      Paul Lamar

I am definitely interested in buying a few more and I would like to
change my mine from charge cooled to oil cooled so please show us how

David Mikesell

The hardest part is adding an oil seal to the rotor to keep
oil smoking down. It can be a spring loaded short steel thin cylinder.
Similar to a Mazda rotor oil seal.

All roller bearings are replaced by oil fed plain beatings.

The oil seal goes about where the red line is on this picture of the
rotor on both sides. An oil squirter is added to the e-shaft and holes
drilled to supply oil to the plain main and rotor bearings. A bushing is
added to the rotor to accommodate a plain rotor bearing.

Kevin email address is:

Kevin Richey  <gyroKevin@gmail.com>

Paul Lamar


Once converted, what would the HP/Torque/RPM values be like?

Bradly Windsor

Surprisingly the displacement  is almost as large as a single rotor Mazda 12A.
It is therefore likely to be similar.

The compression ratio is rather low at 8.5 to one so screwing inserts
into the bath tub depression in the face of the rotor to up
the compression ratio would work.

Here are the basic specs.

BTW Back in WW II CW improved the cooling on the air cooled R3350 by
pressing additional sheet metal finning between the cast cooling fins on the cylinder
heads.  It sounds likely the same trick will work on this engine to improve
the continuous HP rating.

Paul Lamar



So Paul, if it is close to the 12A, would just building a single rotor 12a
be quite a bit easier? The oiling passages and such are already there plus the
  benefit water cooling jacket too.

What do you think the assembled weight of a single rotor 12A  might be?


David Mikesell


Well over 150 pounds with out aluminum end housings or the cooling
system.

Here is what the OMC sheet metal aluminum fins might look like.
I suggest making a simple tool to press them out of sheared
strips of .016" thick 5052 aluminum alloy. The idea is to press
fit them  between the OMC cast fins.

Also if you make an insert for the rotor to increase the
compression ratio make it out of Stainless Steal.
SS has a lower coefficient of heat transfer so less heat
will make it's way to the rotor roller bearing.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.