It occurred to me if you pump enough oil into the rotor roller
bearing it will cool it. Normally a roller bearing requires
very little oil and that is why they are used in charge
cooled engines. The trouble is there is not enough oil
flow to cool it at high power levels mixing small amounts
of oil with the fuel.
The engine will also need a scavenge pump to get the
hot oil out and through a oil cooler and back into an
oil tank.
On the OMC all that is needed is one small hole in the back side
of the eccentric lobe to feed high pressure cooling oil into the rotor
roller bearing. High pressure cooling oil is fed into the eccentric
shaft from one end or the other.
There will also be a hole in the case just beyond one or both of the
main bearings to suck the excess cooling oil back out. Some the of the
fuel mixture will be sucked out as well but the fuel will go to the bottom
of the oil tank and can be recovered.
If the intake plumbing is changed so no mixture goes into
the main bearings and through the rotor then no fuel will
be sucked out with the cooling oil. In other words just a
simple p-port is all that is required. In fact there will then
be no mixture in the center of the engine at all.
Here is a scavenge pump on ebay for $219. One section can be
used as the pressure pump.
This is A MAJOR DEVELOPMENT for charge cooled engine
including the AIXRO if it works.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.