Subject: Some Results from today TTC runs
From: paul lamar
Date: 7/26/2016, 5:53 AM
To: A10-Me-Earthlink




 When we turned on the water injection the intake air temp went from
 200 F down to 140 F. The P38 in WW II was limited to 140 F intake
 temp or the Allison detonated.


 The cross counter flow  heat exchanger is working fabulously.!
 It is far exceeding my wildest expectations. We may not have to
 use the spray bar at all. It might even cool a four rotor.
 Cooling water temp on the TTC is not getting over 120 F.

 I suspect the cross counter flow is working better than the
 theoretical 15% improvement.

Also I suspect  the wonderful louvers fabricated by Dan's composite people
are working to suck air through the heat exchanger.

 Paul Lamar


 Paul, turning on the water injection is the prudent thing to do.
 You are exactly right thinking that it will offset detonation.

 It looks like you've gotten your oil pressure sending unit working
 on some of the runs.

 Also you could change the scale on your water/air/oil temps log to
 50 to 250.

 Your AFRs are becoming quite stable in the full power range.

 You're looking good! Barry Bordes


Thanks Barry.

Yes. I'll ask Neils to increase  the range of some of the pressures and
temperatures to put them in the middle of the graphs.

How does one do that Simon in the Motec software?

Surprisingly we don't think the engine is detonating however it
definitely  effects the peak horse power. Probably pre-ignition is
a better term where peak combustion pressure occurs before the optimum
time in the cycle. When you look at the spark plug there are tiny
balls of what looks like metal deposited on them. Fortunately the
Iannetti ceramic apex seals don't break.

Paul Lamar

 The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.