Subject: Glasair Steve Izett Reno Racer.
From: paul lamar
Date: 8/17/2016, 5:54 AM
To: A10-Me-Earthlink


 Hi Steve,

 How is it going?  Did you get the engine problem fixed?

 I decided to use a Glasair for the 4 rotor Reno racer. That  means I
 need to move the firewall and pilot aft.  Could you stick your cell
 phone in there behind the firewall and take some pictures. I want to
 see what I will be up against. You will need  a flash or perhaps a
 light bulb. If you can scan some of the plans in that area that would
 also be great.

 I think I will use one Maximite per rotor for the EFI. Why not? They
 are low cost. I'll use another for the EFIS. The analog inputs are
 high impedance so four or more Maximites inputs can be connected to
 one sensor if need be. Of course multiple sensors could be used as
 well. Lots of computer power and lots of redundancy as well. Motec
 and Haltech both sell a range of sensors compatible with the
 Maximite.

 Same goes for the mixture adjustment pot on the instrument panel.

 I decided to move the turbo aft of the engine now that I understand
 the turbo exhausts manifold better. It is exhaust gas velocity
 driven and not pressure. That will also simplify the motor mount.

 I looked at a Lancair Legacy and it has the same aerodynamic problem
 as the Sea Hawker Glass Goose to a lesser extent. The Glasair tail
 cone is also five times stiffer in torsion  as well. It has already
 gone 400 MPH.

 The gear box will be Alison truck TX based.

 Paul Lamar



Hi there Paul
Our problem was plugs. Swapped in the NGKBR10EIX (after grinding down a plug socket)

So she now does the following static I think reasonably rich:
WOT Prop set fine        7467 RPM 29.8 Inches EGT’s 1647&1497 23.7 GPH Fuel Pressure 43PSI Oil Pressure 68PSI
WOT Prop set course    5407 RPM 30.3 Inches EGT’s 1579&1494 16.7 GPH Fuel Pressure 43PSI Oil Pressure 56PSI
The EM3 fuel flow is not calibrated yet so not sure how close the GPH likely to be and therefore power levels.

Photo/drawing I have on hand below.
I’ll try sending you the fuselage construction handbook for the Super II, you may want a Glasair III which is strengthened
for tighter speeds and 300hp, but I think the dimensions are similar.

Cheers
Steve

Thanks a bunch Steve that stuff will be really useful in planing.
I may not have to move the pedals or the pilot back.

What is the gap on the new plugs?

BTW what computer or cell phone did you use to send that message?
It does things a bit different when it comes to attached jpg's.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.