Subject: New Motor Mount/plate for my design
From: paul lamar
Date: 8/21/2016, 9:24 PM
To: A10-Me-Earthlink


Paul,

Here is the new motor mount plate I have come up with for my design.  You’ll notice that I rotated the rubber bushings 90 degrees.  I don’t know if that is workable or not, but it helps with packaging in the limited space I have.  You can also see where I relocated the starter to.  It was a little easier to put it there than on the other side, at least as long as I had to co-locate one of the motor mount bolts with one of the starter bolts.

Attached are a couple shots of the new plate and rough drawing of the mount tubes.  Mostly just enough to verify they’re not interfering with any major components.  As you can see I haven’t put the finishing touches on the plate yet as I would like your opinion on wether it’s a workable solution.  Also attached is the Rhino file of most of the major firewall forward components and cowling

Thanks,

Will Aldrich

Looks good Will.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.