Paul
I have followed you for many years and I ran into the above car
last week
and bought it. Please tell me what 2 cycle oil to mix with the gas
and what
to do to keep it running.
Peter Duffecy
You lucky dog. Most that age have over 300,000 miles.
Use Walmart 2 cycle oil offered in gallon cans.
It has an injection pump so you don't need to mix oil with the fuel
IF the
nylon lines are still OK. A BIG IF.
At that age they are brittle and could crack at any moment. I would
replace
them with steel brake line but that might take a lathe.
These cheap plastic lines are critical to the life of the apex
seals, and
engine for that matter, if you are not mixing
2 cycle oil with the fuel.
Paul Lamar
Should I assume that the lines are bad and mix oil till I can be
sure. How
can you check these and I do have a lathe available to me.
Peter Duffecy
Yes by all means that is the safest way to do it.
However they could be cracked and there could be some engine damage.
The engine may still run. It is a good idea to check the oil lines
and the
compression.
Nylon oil line failure is the main cause of Rotary engine failure.
If it
gets apex seal oil it will last at least to 300,000 miles and
probably a lot
more.
The apex seal wears very roughly at the rate of .001" per hundred
hours at
full throttle. The seals probably can tolerate .030" total wear.
That would
be 3000 hours. If you put Iannetti silicon nitride seals in it you are
looking at 20,000 hours :-)
Paul Lamar
Paul,
Where is the best place to get Iannetti apex seals.
Chris. Hoskins in NZ
I like Mazdatrix. Tell them to send it parcel post. It is about
half the
cost of UPS or FedX Or send it to the hotel where your NZ Air pilot
friend
lays over.
That is in Manhattan Beach about 10 minutes from Mazdatrix.
Mazda RX7 and Rotary Engine Parts and Accessories
2730 Gundry Ave.........Signal Hill, Ca. 90755
562-426-7960 For Parts Ordering, and General info
562-426-4460 For Local Service and Parts
562-426-9646 FAX
Open Monday - Friday 8:30 to 4:30 (Closed 12:00 to 1:00 Pacific Time)
Paul Lamar
Thanks for the info Paul.
Chris Hoskins
Your welcome Chris.
Paul lamar
Paul
I have been busy and not had a chance to do anything with the car. Does
anybody know of a place in the Chicago area that can work on rotary
engines. I checked the local Mazda dealer and they were a zero.
Peter Duffecy
Best bet is do it your self. They are pretty simple.
Perhaps someone on here lives in the chigago area.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want
off the
list PLEASE let me know and I will remove you. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright
1998-2016 All world wide rights reserved.