Subject: Allison PSRU no planet carrier. Reno racer.
From: paul lamar
Date: 8/22/2016, 10:18 PM
To: A10-Me-Earthlink

The ring gear is exactly 7 inches in diameter. So a 8 inch OD tube with
1/2 inch wall is just right. A 7.5 might work if you shave some meat
off the outside of the ring  gear.

The bulk heads can be cut from aluminum plate
on a band saw (or you can buy rounds) and trued up in the  lathe.
Use a bunch of extended point set screws to center and lock the ring gear.
The nose can be bar or tube. Best to just bolt the parts together
with a bunch of 1/4 inch bolts.

One might get two housings out of one 12 inch long tube.

BTW the ring gear alone weighs 4.2 pounds. Cutting it down to
the width of the planet gears will get it down to roughly 3.6 pounds.

the input shaft and sun gear are 6 pounds.

The planet carrier, un machined, is 17 pounds. One may get it
down to 10 pounds by machining it. It is very VERY expensive to cut it down
so don't even think about it. Take the planets out and
make a new planet carrier out of 6061 T6.

----------------------------------------------------------

This is it. No separate planet carrier.

The front and back flanges become the planet carrier further reducing
the cost and weight. A custom aluminum planet cage would
cost a lot in therms of NC machining time.

The Allison comes with 3 planet gears but you can put in
up to six. If you only use three the other three can be larger in
diameter spacers up to one inch which will stiffen it up. I think three
are enough as this is a real heavy duty transmission. Those planet
gears are rather heavy.

The bolts are ordinary  grade 8.... 7/16th bolts. The hollow planet shafts
  are about 5/8th OD and must be hardened and ground for the needle
bearings in the planet gears.

The correct size  shoulder bolts are hard to find. Also very expensive.

  I put in the Jerry Bass helical gear thrust bearing. It is the blue bearing in
the 3D's.

The planet shafts are recessed into the front and back flanges for accuracy
and torsional stiffness.

Paul Lamar

Planet rebuild kits are readily available from Allison.  I would think Ti or Gama TiAl
would be the way to go for the planet carrier. Better fatigue resistance and
lighter than the steel. There is one transmission that has a 3.5:1 low gear
without being compound. I think it is a MT640.

Dale Davies

This one is 3.1 to one according Aubrey.

Here it is put together. Very compact. Good for 1300 HP Reno 4 rotor.
I  suspect it will be around 30 pounds. 5 pounds less than the Bell 47
with out the Sonja :-)

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.