You are not going to believe this.
This makes an e-shaft cheap to manufacturer.
It takes a special right angle tool to drill the holes but that can
be done.
These lobes are made in quantity by an NC mill and then hardened and
ground.
Then they are merely bolted to the e-shaft at the correct
orientation for the number of rotors. Every 90 degrees for a 4
rotor.
This assumes 200 foot pounds of torque for each rotor. A 4 rotor
turbo engine would therefor have 800 foot pounds of torque and 1218
HP at 8000 RPM. Right about what we are getting per rotor on the Time
To Climb engine.
The 2400 pound number shown is the average shear load. Peak shear
load would be about twice that. Each bolt takes half of the total
shear load.
The 3/8 shoulder bolts shown are 140,000 psi. The shear area is .110
square inches. Lets say each bolt has a shear force of 2400 pounds.
That means the bolt is capably of resisting 15,400 pounds. A huge
factor of safety of six.
Each lobe is an I beam to cut weight.
I could get a patent on this but it would take years and cost a
bunch of money as well as defend it. I am donating this to the
Wankel community.
You cannot get a patent on this as I have already published it :-)
This also makes assembling a one piece e-shaft four rotor with 5
main bearings easy. No unusual main bearings devices are required
such as the Offenhouser device and method. This also cuts the cost of
the engine. You can build it up like stacking pancakes.
BTW Very few people realize the Mazda two rotor e-shaft is three
pieces. They are spin welded together. This could be spin welded as
well but some of the advantages would be lost. For example suppose
one rotor bearing was scoured from dirt in the oil. Just replace that
lobe.
Paul Lamar
Paul, nice idea, what about splines or key's on the shaft, and
broaching the eccentric?
Steve Carlisle
No room for splines and you cannot broach an I beam eccentric.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.