Subject: Pre-chamber initiated jet ignition
From: paul lamar
Date: 8/29/2016, 12:14 PM
To: A10-Me-Earthlink




Paul,

During my combustion testing on rotary engines I kept finding an anomaly
of autoignition.  Usually about 6 to 8 cycles on a normal 8000 RPM
sweep. It seemed to be caused by exhaust reversion continuing to the
next intake cycle and causing the auto ignition. Very scary to have an
uncontrolled ignition source.... but the good news was that the burn
rate on those cycles improved!

After a little study I discovered a Honda experiment that concluded with
a race bike for the Dakar rally that had a two-stroke engine running
without ignition and getting 20% better fuel economy. But the details
were very sketchy.

Fast forward to Formula 1 today. They are using what is known as
Turbulent Jet Ignition. This process is not new, it was discovered by
Ricardo and published in his papers from 1911. The latest version of
this process by Mahle uses a direct injector and spark plug in a very
small pocket that injects active radicals into the main combustion
chamber. The engine can then be operated almost like a diesel and the
burning process is spread throughout the combustion chamber by quenched
active radicals causing a very fast burn rate. Lean burns have been
demonstrated to lambda 2 or 30:1 AFR gasoline and throttling losses
greatly reduced.

This is why Formula One is now  producing the same horsepower but is
using 40% less fuel.
Mahle  is reportedly working with Ferrari but Mercedes seems to be way
ahead of them.

This ignition process seems to be a perfect fit for the rotary engine...
especially on aircraft where BSFC is so important.

Barry Bordes



How are you doing the combustion testing on rotary engines?
References for the Honda experiment?

http://papers.sae.org/2010-01-1457/

The reason Formula One engines are burning less fuel is because they are
turbo compound
hybrids. A formula 1 engine is either on full throttle or on the brakes.
The power recovery
from braking is  a large part of that.

http://www.rotaryeng.net/Oxford-TC-talk.mp4

We have known for years that leaning the rotary up to 18:1 improves the
BSFC at the expense
of power.

If you have a leaking apex seal hot exhaust gases from the leading
chamber can
pre ignite the following chamber.

Paul Lamar


I am using an Optrand sensor in the leading spark plug.  In conjunction with a TFX logger.

See attachments for the type data it provides.
The first is a peak pressure single cycle with exhaust opening pressure and temp.
The second shows burn rate
The third shows a complete 7000 rpm run.... tuning a new EFR turbo... the lower cells around 4000 rpm are retarded.

I don't have the Honda paper number but check SAE 2010-01-2263 for past and  present research.
 Barry Bordes

Looks like it is sparking  After Top Dead Center.

We use 22 degrees BTC

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net/You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.