Subject: The correct flywheel for RX8
From: paul lamar
Date: 9/4/2016, 1:48 PM
To: A10-Me-Earthlink



Hello Paul,
Can you tell me which flywheel is the correct one to fit to a RX8
engine. I have removed the manual flywheel.
Do I need a balance section from the automatic engine as well as the
flywheel. Your help is appreciated .
Regards

Mark Dillar

You need an RX8 automatic transmission flex plate and counter weight.
Don't use Tracy's flex coupling. It over stresses the flex plate
and may cause it to crack. Of course you can buy an after market
expensive chrome molly steel flex plate/flywheel. That is what
Dave Leonard did.

Or use one of our couplings like the one used on the TTC engine.

I have some water jet cut parts left  for the steel version.
Weld it your self.

Paul Lamar

Thank you Paul,
It's early days for me working on the Mazda so I shall start the search
for the flex plate and counter weight.
I shall hold on the coupling but will go back through the emails to see
the pictures of the ttc coupler
Thank you for the information that I do get from your News Letter and I
hope you don't mind if I should forward further questions to you

Mark Dillar

I sent pictures of the TTC coupling. Did you see the aluminum version?
That was the TTC coupling. If you are using a cell phone they sometimes are
limited to the number of pictures they will download.

The TTC coupling could be half the length for an ordinary two rotor.
The diameter would be the same as it picks up the six high strength
 bolts in the counter weight.

The stock E-shaft and counter weight are way over designed for a 250 HP
normally aspirated p-port 2 rotor. I suspect 1500 HP would be no problem.
The three and four rotor turbo's are using the same parts.

Here are some more pictures of the TTC coupling.
The flex plate shown is an after market aluminum version.


Paul Lamar

Paul ,I am using a stock standard and old laptop. No pictures came through
with this message but I shall look back at old messages
Mark Dillner

I screwed up. The next message will have the TTC coupling pictures.
The one before this one :-)

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net/YouTube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.