Subject: What Oz needs is a fast long range bush plane
From: paul lamar
Date: 9/4/2016, 9:11 AM
To: A10-Me-Earthlink



A 500 HP turbo two  rotor could be made and sold for less than $20,000
using stock Mazda e-shaft, rotor housings and rotors. Aluminum end
and center housings.

The 500 HP  two rotor rotary  is needed to get off fast on short, rough runways.

This will hold four people or two people and two stretchers.

The key to a bush plane is great big balloon tires.
Unfortunately they are a lot of drag which effects the speed and range.

The catamaran configuration is ideal to retract two large balloon tires
with out adding a lot of drag and complication.

The two long hydraulic cylinders on each wheel feed into an accumulator
when in the landing mode. When retracting the accumulator is
turned off and the oil sucked out of the top of the  cylinders to retract the gear.

Almost all loads from the gear feed directly into the spar. The strongest
place in any airplane.  The engine is mounted above and to the spar. It can be
a tractor or pusher.

Keep it  simple.

I'll bet some one can get a grant from the Oz gov as it is much lower cost
than the turbo props they are using now. This is low cost  enough so
ranchers, farmers  and so fourth can afford it. No need for waiting for a flying
doctor turbo prop to get there if someone is injured or gets sick.

You can show this at Oz-Kosh Dave.

Paul Lamar


Very nice. So could you have balloon tires and hydro foils in one configuration?

Thanks, Paul.

Sincerely,

Boyd Thompson

I thought about that but it is difficult as the gear and the hydro foils, I think,
want to be in the same position relative to the CG. The other problem is
the empty weight would be higher.

What can be done is seal the wheel wells, beef up the gear doors and
land in water if absolutely necessary. For example running out of gas.

I am working on a simpler and cheaper mold for making the composite fuselage.
Part of it can be flat and consequently  plywood can be used for some of the male
mold.

What works for mold separation is ordinary duct tape. You cover the entire
male buck with it. Plywood and all so it matters not what you make the male
buck out of. One could use blue Styrofoam (expensive)  for the compound surfaces  or
ordinary wall plaster. Much cheaper. Also thin galvanized sheet steel as found
in air coordinating  ducts could be used for simple curved surfaces.

We used special auto body styling clay at Chaparral.

The key is slather on micro balloons mixture on the cured layup and sand
most of it off. That tells you were the depressions are. Works for foam core
fiberglass wings as well.

Here is a hood for an Austin Healy Sprite I made 55 years ago.
The silver bumpers are  part of the hood made from fiberglass.
Beefed up of course.

If I knew then what I know now learned from Dan Gray about making fiberglass
molds it would have been much smoother :-)

I don't think we had duct tape in those days either :-)

Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.