Subject: How to build a glass smooth composite wing.
From: paul lamar
Date: 9/11/2016, 12:04 AM
To: A10-Me-Earthlink

Burt Ruttan invented the hot wire solid foam core wing with fiberglass
covering.  Unfortunately it takes a good year to sand it.

I had an idea several years ago to use dry wall anchors to fasten
a previously laid up thin skin to Styrofoam ribs.

I think someone else had already invented something similar
 back in 2008 when we first discussed this.

Here is a picture of the Zinc anchor I had in mind. I did not like the idea
of leaving them in there.

It would be a problem grinding them to to fair them in.
They are also availably in thermoplastic which would be easier
to sand. The anchors only hold the skin in close contact
until the epoxy sets up. The ribs are covered in thin glass fiber
to add the necessary bending strength and bonding strength
of the skin to the ribs. The epoxy bond is good to 3000 psi
so a one inch thick rib is more than adequate.

Basically it is the same idea of riveting a sheet of skin aluminum to
aluminum ribs.

The drywall anchors are not ideal. They could be larger in diameter
to fully use the limited shear strength of blue Styrofoam.

So recently I realized larger diameter dry wall anchors could
be turned out on a NC lathe in aluminum rapidly and at low cost.

Point .75 inch diameter ought to be able to generate higher clamping forces on
the blue Styrofoam.

The fact is epoxy will not stick to raw aluminum. Aluminum oxidizes
rapidly after being machined and that is what causes the epoxy bond
failure with the dry wall anchor.

That turns out to be a good thing as now they can be unscrewed and
used over. The left over holes can be filled with a micro balloon mixture and
sanded.

Now about that glass smooth skin. Buy a sheet of plate glass and lay
the skins up on that.

I am working on the design of the carbon fiber six inch diameter tube spar.

The spar is the heaviest part of the aircraft structure so it pays
to make it out of expensive carbon. The skins of course can be glass
or carbon depending how much money you want to spend.


Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.