Subject: How to build a glass smooth composite wing.
From: paul lamar
Date: 9/11/2016, 12:34 PM
To: A10-Me-Earthlink



Burt Ruttan invented the hot wire solid foam core wing with fiberglass covering.  Unfortunately it takes a good year to sand it.

I had an idea several years ago to use dry wall anchors to fasten a previously laid up thin skin to Styrofoam ribs.

I think someone else had already invented something similar
 back in 2008 when we first discussed this.

Here is a picture of the Zinc anchor I had in mind. I did not like the idea of leaving them in there.

It would be a problem grinding them to to fair them in.
They are also availably in thermoplastic which would be easier to sand. The anchors only hold the skin in close contact until the epoxy sets up. The ribs are covered in thin glass fiber to add the necessary bending strength and bonding strength of the skin to the ribs. The epoxy bond is good to 3000 psi so a one inch thick rib is more than adequate.

Basically it is the same idea of riveting a sheet of skin aluminum to aluminum ribs.

The drywall anchors are not ideal. They could be larger in diameter to fully use the limited shear strength of blue Styrofoam.

So recently I realized larger diameter dry wall anchors could be turned out on a NC lathe in aluminum rapidly and at low cost.

Point .75 inch diameter ought to be able to generate higher clamping forces on the blue Styrofoam.

The fact is epoxy will not stick to raw aluminum. Aluminum oxidizes rapidly after being machined and that is what causes the epoxy bond failure with the dry wall anchor.

That turns out to be a good thing as now they can be unscrewed and used over. The left over holes can be filled with a micro balloon mixture and sanded.

Now about that glass smooth skin. Buy a sheet of plate glass and lay the skins up on that.

I am working on the design of the carbon fiber six inch diameter tube spar.

The spar is the heaviest part of the aircraft structure so it pays to make it out of expensive carbon. The skins of course can be glass or carbon depending how much money you want to spend.


Paul Lamar

I have used some preformed GRP sections on my Pioneer 300 where the curves are too tight to form from 1.5mm ply. The 300 is basically a timber aircraft with some preformed parts so the glass can be fixed using staples, these are easily removed afterwards. Epoxy adheres very well to Styrofoam but don’t use polyester resin.

Another way to fix the skin to the Foam would be to use a vacuum bag, just place a large bag over the wing and suck out the air with a vacuum cleaner. Large Polythene sheets can be turned into a bag by clamping the edges to be sealed between two pieces of waxed  timber leaving 5or6 mm protruding out and then run a small flame along the protrusion until the polythene melts and forms a seal. I used to make hot air balloons this was as a kid. The waxed edge will stop the melted edge from sticking to the timber.

Be careful with the thickness of the GRP as it is about 1600 KGS per cu meter compared to about 600 for plywood.


Andrew Campbell.



The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.