Burt Ruttan invented the hot wire solid foam core wing with
fiberglass covering. Unfortunately it takes a good year to sand it.
I had an idea several years ago to use dry wall anchors to fasten a
previously laid up thin skin to Styrofoam ribs.
I think someone else had already invented something similar back in
2008 when we first discussed this.
Here is a picture of the Zinc anchor I had in mind. I did not like
the idea of leaving them in there.
It would be a problem grinding them to to fair them in. They are
also availably in thermoplastic which would be easier to sand. The
anchors only hold the skin in close contact until the epoxy sets up.
The ribs are covered in thin glass fiber to add the necessary bending
strength and bonding strength of the skin to the ribs. The epoxy bond
is good to 3000 psi so a one inch thick rib is more than adequate.
Basically it is the same idea of riveting a sheet of skin aluminum to
aluminum ribs.
The drywall anchors are not ideal. They could be larger in diameter
to fully use the limited shear strength of blue Styrofoam.
So recently I realized larger diameter dry wall anchors could be
turned out on a NC lathe in aluminum rapidly and at low cost.
Point .75 inch diameter ought to be able to generate higher clamping
forces on the blue Styrofoam.
The fact is epoxy will not stick to raw aluminum. Aluminum oxidizes
rapidly after being machined and that is what causes the epoxy bond
failure with the dry wall anchor.
That turns out to be a good thing as now they can be unscrewed and
used over. The left over holes can be filled with a micro balloon
mixture and sanded.
Now about that glass smooth skin. Buy a sheet of plate glass and lay
the skins up on that.
I am working on the design of the carbon fiber six inch diameter
tube spar.
The spar is the heaviest part of the aircraft structure so it pays
to make it out of expensive carbon. The skins of course can be glass
or carbon depending how much money you want to spend.
Paul Lamar
Paul, The method you propose sounds similar to one method Alex
Strojnik used, for his sailplanes, you may find info of use to you
in his writings.
Yes, the idea is to layup the skin against a very
smooth surface and let that be the outside, so no filling, etc. If
it vacuum bagged with perf and a bleeder layer inside the bag it can
considerably reduce the weight of the layup (compared to hand-layup
without getting out the excess epoxy.) Glass makes a good form, but
very smooth gloss Formica (sold for countertops) is lighter and
cheaper.
Regarding the carbon-fiber spar--any reason to go with a
tubular spar? That's a lot of extra weight and money for the CF--the
only stuff that's significantly contributing to the strength is at
the top and bottom of the spar. The glider guys use "Graphlite"
pultruded CF rods bundled at the top and bottom caps, with just
cloth layed up between them (as the web). It's a good use of
materials, weight, and money.
Jim Marske has written quite a bit
about building these spars, with equations for determining the number
and type of rods needed, etc. He also sells the pultruded rods (but
they are available elsewhere, of course).
Mark Waldron
A box or a round tube spar gives higher torsional stiffness.
With fowler flaps the center of pressure moves aft placing a
torque load on the spar. Some designs handle this by using two spars.
Sail Planes don't generally use flaps
Just spoilers. I plan to use fowler flaperons and spoilers.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.