Just a thought to chew on. I think most folks love the old radial
engines. If you look at the max diameter of the wright engines, it
is about 54 inches.
Lets stretch our imagination and put 3 to 9 rotaries within circle
with the outside being 54 inches. They could be mounted with the
base outward easily within the 54 inch circle.
Each engine can have a gear on the output shaft driving a center gear
on the prop shaft, easily making the 3 to one gear down required for
the prop. Nine rotary engines with 2 rotors each times 650 hp each
is 5850 .hp and the same frontal area as an old radial engine.
Maybe less weight too.
Maybe an overrun clutch on the drive gears to shut a few down for
cruise.
Really good redundancy as well. Might draw one up on the cad
system.
Ken Burdgess
Interesting idea.
Don't stop at 3 to one. Make it 4 or 5 or more to one and use a
really big prop or helicopter rotor. One way to get gobs of torque
out of several rotaries.
That would make a really great helicopter engine.
Paul Lamar
Why not go further with the helicopter version and add a hollow shaft
over the current one and use
lay shaft and gears to run the outer shaft in reverse direction so you
then have contra-rotating blades
eliminating the need for a tail prop to stop the chopper spinning.
Colin Dale
The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.