I do have a question concerning where I should be taking my AFR
readings on my 13b powered RX7. I have one sensor installed on the
header about 8" from the engine and as I accelerate I see readings
going from 14:1 at 3K RPM and going to 10:1 at 75K RPM as I am on
track.

Two weeks ago I ran the car on a dyno after my second session of the
day and that showed that in fact, the AFR reading at the top end is
actually just going lean at 75K RPM. So, is it better to install the
sensor back at the rear of the exhaust, just down stream of the
collector and before the muffler?  Thanks for your input. Love
reading the emails.

Regards,  Ray Hellstrom

Check the fuel pump volume Ray. Sounds like the fuel pump is running
out of grunt.

Paul Lamar


Paul,
My fuel pressure stays at up around 6 psi and I don't see it dropping at any time.
I am questioning where to read the AFR. During the runs on the dyno I saw the Innovate AFR meter in the car topping out at 10:1 at 7.5K RPM while the AFR sensor on the dyno was starting go lean. Is it just the distance and mixture of both front and rear rotors.
Regards,
Ray Hellstrom


My mistake. I assumed you had fuel injection.

My Motec people say it does not matter where  the O2 sensor  is.

Do you have a wide band ?

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.