I am thinking of machining a batch of one rotor e-shafts.

If your interested I will put you on the list.

Paul Lamar


very nice job Paul.

When I opened the picture I was hoping it was the new design you had sent out on the list a few months ago.
You know the one with the eccentric bolted in place on the shaft.

Still very nice.

David MIkesel


I had second thoughts about that. This one uses all stock Mazda parts like the
alternator pulley and the RX8 diecast front cover with water pump and  shaft seal.
This will lower the cost. If one has a two rotor engine this is easier to
make it into a one rotor.  Racing Beat alloy front and rear end housings will fit.

Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.