Subject: Disc Brake on Gyroplane to slow Rotors
From: paul lamar
Date: 9/29/2016, 9:25 PM
To: A10-Me-Earthlink



Paul,

I searched for pictures of the disc brake on Gyroplane Rotor Mast, did
not find any displayed. As per your "I see no need to do that. Did the
gyro plane do it in the air or just after he landed?" I did find that a
few websites stating they slowed the rotors after landing.

I found very few references to this, I think it should be checked out
some more.

George F. Curtis Jr.

I have about 500 hrs in gyros, built 3 from scratch using plans, even built a set of wooden blades and flew them.

The disc brake he is talking about is off a mountain bike, I have used it too as a rotor brake. You use it after you land if the winds are high. You normally taking with the rotors spinning unless taxing into a tight area. However when you are done taxing and want to tie down you have to stop the rotor, you gently apply the brake and slow the rotors slowy, not aggressively. The older way was to tilt the rotors top into the wind and wind brake them, that can be dangerous if the wind is high, it can cause the blades to flex down and they can hit the tail or the airframe.

David Mikesell



The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.