Ok, so today I took the time to take apart a Sachs 293 38hp rotary.
I have attached some pictures. Now I saw and heard this engine running
so I was surprised when i took it apart and saw metalset epoxy used to
repair the inside surface where the apex seals run, also the entire
engine case is made from aluminum. The only steel is used in the end
plates where the bearings are.
Anyway here are some pictures to look over. Ask questions if you want
and i will do my best to answer them.
David Mikesell
Great pictures David. Thanks.
You can fix this by tig welding some aluminum on the bad spots and
sanding them
to shape.
An oil squirter in the end house can cool the rotor with a pressure pump and
scavenge pump or just an oil pan instead of the scavenge pump . A hose
can run
to a container under the engine and gravity will scavenge it.
Close off the return passages for the charge cooling.
Paul Lamar
If end housings are AL, they must be hi silicone content and lapped
like the Vega block and ZL1 chev 427 AL blocks. Special lapping to pull
the AL below the silicone so the seals (rings) run on the silicone not AL.
Dale Davies
There others ways of doing it.
There is some sort of coating on the RB housing. I have not been able
so far
to find out exactly what it is.
Here are some pictures of the front housing (car). Note the two large
cracks in the wear surface.
My end hosing are guaranteed not to do that.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.