Ok, so today I took the time to take apart a Sachs 293 38hp rotary.
I have attached some pictures. Now I saw and heard this engine running
so I was surprised when i took it apart and saw metalset epoxy used to
repair the inside surface where the apex seals run, also the entire
engine case is made from aluminum. The only steel is used in the end
plates where the bearings are.
Anyway here are some pictures to look over. Ask questions if you want
and i will do my best to answer them.
David Mikesell
Great pictures David. Thanks.
You can fix this by tig welding some aluminum on the bad spots and
sanding them
to shape.
An oil squirter in the end house can cool the rotor with a pressure pump and
scavenge pump or just an oil pan instead of the scavenge pump . A hose
can run
to a container under the engine and gravity will scavenge it.
Close off the return passages for the charge cooling.
Paul Lamar
Well I was thinking of keeping the charge passages as a way for the
cooling oil to drain from the engine. Those passages line up with the
rotor cooling passages so oil will get slung out the charge passages on
each side, plus they are the way the shaft bearings were oiled, I will
use them as the oil return passages for the bearings. I will put the oil
injectors just past those passages in the direction of rotation. That
way the oil will get about 300 degrees of rotation to soak up heat from
the rotor before it is pushed out the charge passages.
My goal is not only to oil cool the rotor, with synthetic oil being
injected on to it, but to water cool the engine also. I am sure the
block is cast from A356 aluminum like most light weight engine blocks. I
can get the dimensions from this one and design a new body with a bit
larger outer dimension to allow for water cooling. And new end plates
too for water cooling.
I am going with 6061T6 and use my cnc mill to make the new parts. 6061T6
is pretty close to A356 as far as temperature limits and strength. I can
also get it coated with Niksal or another type of high strength and high
temp coating. I think the first ones will be bare just for testing the
set up to see if it works.
David Mikesell
You don't need them. The oil will find its way out through the way it
came in.
That is exactly the way the Mazda works.
Where are you David? Tell me by private email if you wish?
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.