Hi Paul, what is the best way to get the seals on the rotor, Apex seals,
side seals out without damaging them. The ones in this old sachs rotor
are stuck and I don't want to tear apart to get them out.
David Mikesell
Soak it in solvent for 24 hours. Gasoline or MEK or acetone or even
kerosene.
For some strange reason auto transmission fluid sometimes works.
BTW the Sach is a good engine to do R&D on apex seals.
Try glass filled teflon. Back in the days Mazda was doing
research on the subject that was not availably.
The oil squirter should keep the rotor temperature well below
500 F.
Perfect for the side seals as they run nowhere near the temperature
of the apex seals.
Paul Lamar
Well I plan on using the addition of the oil squirter so I can bring the
temps up to get more hp out of it.
You think the glass filled teflon will work for apex and side seals? I
would think it might get wedged or stuck in the slots. I would guess
even though it is glass filled still a bit soft though.
If it would work that would be nice to have a all aluminum housing that
will last with nice affordable seals that will last too.
David Mikesell
This carbon filled Teflon is looking great. I suspect the aluminum side
housings can be
simply anodized and that is it. Much cheaper than any type of flamed sprayed
coatings.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.