Subject: apex seals and side seals
From: paul lamar
Date: 9/30/2016, 11:52 PM
To: A10-Me-Earthlink



   Hi Paul, what is the best way to get the seals on the rotor, Apex seals,
   side seals  out without damaging them. The ones in this old sachs rotor
   are stuck and I don't want to tear apart to get them out.

   David Mikesell



   Soak it in solvent for 24 hours. Gasoline or MEK or acetone or even
   kerosene.
   For some strange reason auto transmission fluid sometimes works.

   BTW the Sach is a good engine to do R&D on apex seals.
   Try glass filled teflon. Back in the days Mazda was doing
   research on the subject that was not availably.

   The oil squirter should keep the rotor temperature well below
   500 F.

   Perfect for the side seals as they run nowhere near the temperature
   of the apex seals.

   Paul Lamar


   Well I plan on using the addition of the oil squirter so I can bring the
   temps up to get more hp out of it.

   You think the glass filled teflon will work for apex and side seals? I
   would think it might get wedged or stuck in the slots. I would guess
   even though it is glass filled still a bit soft though.

   If it would work that would be nice to have a all aluminum housing that
   will last with nice affordable seals that will last too.

   David Mikesell

   This carbon filled Teflon is looking great. I suspect the aluminum side
   housings can be
   simply anodized and that is it. Much cheaper than any type of flamed sprayed
   coatings.

   Paul Lamar


   Hi Paul and all,
   a friend of mine here in OZ has just supplied disk brake rotors to the
   navy made from 6061 T3 with a hard anodized coating that is rated at 800
   Brinell, which is about 85 Rockwell. This makes it about 2 times harder
   than cast iron. Should be fine with a lubricated rotor running over it,
   especially with carbon filled Teflon seals.

   He did point out that to get a good anodized surface, 6061 T3 is needed
   as the surface will not finish well with cheaper grades due to
   impurities in the alloy.

   So, I think that means we must mill the housings from billet.
   FWIW,

   Dave Mccandless in OZ

   Well we are planning on  milling  the housings from billet.
   No castings. The RB's are castings.


   Paul Lamar


The carbon filled potential nylon probably won't work. In the literature it says it will hold
up at 900 fpm and up to 2500 psi non-lubed and 3500 psi lubed. The distance
around this small rotary housing is more than a foot, so the limit would be 900 rpms.

David Mikesell

Not the apex seals. The side seals go about 1/3 rd as fast in a complex rotating and
translating pattern.

And Teflon "glue" not nylon. Nylon is only good to 200 F. Teflon is good to 500 F

Still worth a try for side seals.

There is no beating a silicon nitride apex seal except for the cost.
Since the rotor is rotating even the apex seals do not rub at 900 fpm at 900 RPM.
Something less.

Paul Lamar


   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube
   http://tinyurl.com/beqqxas
   Copyright 1998-2016 All world wide rights reserved.