Subject: We flew the TTC for 26 minutes today.
From: paul lamar
Date: 10/8/2016, 7:21 AM
To: A10-Me-Earthlink



Not a good video. Lots of reasons for that. However we have three GoPros
on the air plane. One in the cockpit, one of top of the tail and
one on the left wing tip looking at the cockpit. We should get
some better footage from those.

Dan ran the engine for eight  or ten seconds at 57% throttle 7,938 RPM
and 60 inches of HG. He also had it up to 8000 feet. Here is the Motec data sheet.

The cooing system is still working amazing well. I did not expect that.
Perhaps I only need 2/3rd of it. I know we could probably do away with
the oil cooler entirely. However this test tested the oil cooler to the max and the
oil never got above  102 deg F.

EGT's were normal at 1500 to 1700 deg F and the water
injection is keeping the intake manifold air temperature down to 167 deg F.

Paul Lamar



Paul,

Any idea how much HP was put out in test run ?  How was the noise for the pilot, did he have ear protectors or is the cockpit damping noise ?

Sounds like you over built cooling, but its great to see what the top end of cooling can be accomplished, maybe never would have gone that far if not done out of the gate.

George F. Curtis Jr.

Well the HP is getting up there. My guess is at least 500 HP.
70 inches is at least two atmospheres. so 250 HP is common for a p-port
normally aspirated.

The pilot has earphones. We have measured 120 db on the ground. You can hear
it a long ways off. My guess is 2 or 3 miles. Maybe even 5 miles. My hearing
is bad and I could hear it all the time he was in the air. Dan stayed in the
airport vicinity.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.