Subject: Subscribe to news letter rocket rotary
From: paul lamar
Date: 10/9/2016, 6:43 AM
To: A10-Me-Earthlink


I am very interested in your rotary rocket project I can't wait to see it performs the record climb. I am out of Bakersfield municipal airport and have a rv6 and building a rocket and was wondering if I can subscribe to your news letter I heard about. Thanks, and good luck with the record.

Jacob Surges


We just flew it on Friday at Cal City.

How did you hear about it Jacob?


  Not a good video. Lots of reasons for that. However we have three
  GoPros on the air plane. One in the cockpit, one of top of the tail
  and one on the left wing tip looking at the cockpit. We should get
  some better footage from those.

  Dan ran the engine for eight  or ten seconds at 57% throttle 7,938
  RPM and 60 inches of HG. He also had it up to 8000 feet. Here is the
  Motec data sheet.

  The cooling system is still working amazingly well. I did not expect
  that. Perhaps I only need 2/3rd of it. I know we could probably do
  away with the oil cooler entirely. However this test.... tested the oil
  cooler to the max and the oil never got above  102 deg F.

  EGT's were normal at 1500 to 1700 deg F and the water injection is
  keeping the intake manifold air temperature down to 167 deg F.

  Paul Lamar

  Paul,

  Any idea how much HP was put out in test run ?  How was the noise for
  the pilot, did he have ear protectors or is the cockpit damping noise
  ?

  Sounds like you over built cooling, but its great to see what the top
  end of cooling can be accomplished, maybe never would have gone that
  far if not done out of the gate.

  George F. Curtis Jr.

  Well the HP is getting up there. My guess is at least 500 HP. 70
  inches HG is at least two atmospheres (30" HG). so 250 HP is common for a p-port
  normally aspirated.

  The pilot has earphones. We have measured 120 db on the ground. You
  can hear it a long ways off. My guess is 2 or 3 miles. Maybe even 5
  miles. My hearing is bad and I could hear it all the time he was in
  the air. Dan stayed in the airport vicinity.

  Paul Lamar

  Paul,

  Perhaps I'd forgotten what rpm you planned on doing the TTC at,
  but.. If the engine was already at 8,000 rpm at only just over half
  throttle..  is there enough prop left to hold the engine back..?
  Exciting either way..!!!

  bruce buksyk

  Very good question.

  The prop is a fixed pitch climb prop so the aircraft is not near
  top speed. I suspect it is under more load in a climb condition. He
  was flying strait and level at the time. I specifically asked Dan
  about that when he told me he reached 8000 RPM.

  Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.