Subject: Subscribe to news letter rocket rotary
From: paul lamar
Date: 10/9/2016, 4:54 PM
To: A10-Me-Earthlink



I am very interested in your rotary rocket project I can't wait to see it performs the record climb. I am out of Bakersfield municipal airport and have a rv6 and building a rocket and was wondering if I can subscribe to your news letter I heard about. Thanks, and good luck with the record.

Jacob Surges


We just flew it on Friday at Cal City.

How did you hear about it Jacob?


 Not a good video. Lots of reasons for that. However we have three
 GoPros on the air plane. One in the cockpit, one of top of the tail
 and one on the left wing tip looking at the cockpit. We should get
 some better footage from those.

 Dan ran the engine for eight  or ten seconds at 57% throttle 7,938
 RPM and 60 inches of HG. He also had it up to 8000 feet. Here is the
 Motec data sheet.

 The cooling system is still working amazingly well. I did not expect
 that. Perhaps I only need 2/3rd of it. I know we could probably do
 away with the oil cooler entirely. However this test.... tested the oil
 cooler to the max and the oil never got above  102 deg F.

 EGT's were normal at 1500 to 1700 deg F and the water injection is
 keeping the intake manifold air temperature down to 167 deg F.

 Paul Lamar

 Paul,

 Any idea how much HP was put out in test run ?  How was the noise for
 the pilot, did he have ear protectors or is the cockpit damping noise
 ?

 Sounds like you over built cooling, but its great to see what the top
 end of cooling can be accomplished, maybe never would have gone that
 far if not done out of the gate.

 George F. Curtis Jr.

 Well the HP is getting up there. My guess is at least 500 HP. 70
 inches HG is at least two atmospheres (30" HG). so 250 HP is common for a p-port
 normally aspirated.

 The pilot has earphones. We have measured 120 db on the ground. You
 can hear it a long ways off. My guess is 2 or 3 miles. Maybe even 5
 miles. My hearing is bad and I could hear it all the time he was in
 the air. Dan stayed in the airport vicinity.

 Paul Lamar

 Paul,

 Perhaps I'd forgotten what rpm you planned on doing the TTC at,
 but.. If the engine was already at 8,000 rpm at only just over half
 throttle..  is there enough prop left to hold the engine back..?
 Exciting either way..!!!

 bruce buksyk

 Very good question.

 The prop is a fixed pitch climb prop so the aircraft is not near
 top speed. I suspect it is under more load in a climb condition. He
 was flying strait and level at the time. I specifically asked Dan
 about that when he told me he reached 8000 RPM.

 Paul Lamar


Thanks for the fast reply and congrats on the first flight. We fly out of Bakersfield and am good friends with John Harmon and he is the one who told me about your project and then I found your email on a forum. Very cool, I love rotary motors they make a ton of power per displacement and weight, I think it's the perfect motor to reach your goal. Good work on everything it's a really cool set up, I look forward to your progress. Thanks again for the info and reply.

Jacob Surges


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.