Subject: The unsymetrical rotary engine Chrome plating
From: paul lamar
Date: 10/31/2016, 6:33 PM
To: A10-Me-Earthlink



    Nice Paul, good info on the apex seals.

    The chrome plating of the rotor housing is the same technique used
    for Chrome plated piston cylinders?

    David Mikesell

    Yes. I would think any chrome shop could do it. I think they reverse
    the current for a short while after it is done to get a bit of
    porosity on the chrome layer to enhance oil wetting. This would be
    far less expensive than any other kind of effective coating on
    aluminum.

    2.5 million rotary engines prove it works.

    I think they can mask off the surfaces that do not need to be
    chromed.

    My name for the all steel  new design is "Unsymmetrical Rotary"
    Copyright Paul Lamar 2016

    I will scale it up to Mazda size and determine the weight. I'll bet
    it is not much more than a stock Mazda rotor housing. I was right!
    The stock Mazda ( mostly aluminum) rotor housing weighs 6.5 pounds.
    The Unsymet all steel water cooled weighs 7 pounds. Plus or minus a
    few ounces.

    It is all that useless junk on the cold side of the Mazda rotor
    housings.

    The air cooled Mazda version would be about the same weight.

    The way to make the aluminum heat sink fins is gang slitting saws.
    This is the way P&W and CW did it in the old days on radial engine
    cylinders.

    The way to get rid of most of the material in the big block of steel
    is drill a trochoide pattern roughly in the center. Then band saw it
    out. That is the way the Wright brothers built their first crank
    shaft. They drilled a big block of steel then they sawed it to rough
    shape.

    Anybody for an air cooled one rotor Mazda size  rotary engine
    weighing 70 pounds and  putting out 130 HP ?

    E-shaft and rotor the same Mazda parts.

    Of course :-)

    Paul Lamar



When discussing chrome plated surfaces there is two different chromed used. One is decorative chrome used on bumpers of old cars and door handles. The other is hard chrome which is used where wear is injured such as on hydraulic cylinder rods.
It would seem to me that is what is lining the Mazda rotor housings. It is a thicker coating than decorative chrome. After looking at a used rotor housing it looks like the polished finish of a hydraulic rod.
Dale Davies

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.